The CO2SINK (and CO2MAN) project is the first onshore CO2 storage project in Europe. The research site is located near the town of Ketzin, close to Potsdam in Germany. Injection started in June 2008, with a planned injection target of 100,000 tonnes of CO2. In February 2011, around 45, 000 tons of CO2 had been injected into the saline aquifer at an approximate depth of 630 m. This thesis focuses on time-lapse analysis of borehole seismic data, surface seismic data and reservoir characterization at the Ketzin site. Baseline Moving Source Profiling (MSP) data were acquired in the borehole Ketzin 202/2007 (OW2), along seven lines in 2007. The zero-offset Vertical Seismic Profile (VSP) data were acquired in the same borehole. The main objective of the VSP and MSP survey was to generate high-resolution seismic images around the borehole. After modeling and data processing, the sandy layers within the Stuttgart Formation can potentially be imaged in the VSP and MSP data whereas reflections from these layers are not as clearly observed in the 3D surface seismic data. 2D and pseudo-3D time-lapse seismic surveys were conducted at the Ketzin site. Interpretation of 2D baseline and repeat stacks shows that no CO2 leakage related time lapse signature is observable where the 2D lines allow monitoring of the reservoir. This is consistent with the time-lapse results of the 3D surveys showing an increase in reflection amplitude just centered around the injection well. The results from the pseudo-3D surveys are also consistent with the 3D seismic time-lapse studies and show that the sparse pseudo-3D geometry can be used to qualitatively map the CO2 in the reservoir with significantly less effect than the full 3D surveying. The 2nd pseudo-3D repeat survey indicates preferential migration of the CO2 to the west. There are no indications of migration into the caprock on either of the repeat surveys. Amplitude Versus Offset (AVO) analysis was performed on both 2D and 3D repeat surveys. A Class 3 AVO anomaly is clearly observed on the 3D repeat data and matches the synthetic modeling well. No AVO anomaly was observed on the 2D repeat data, which was anticipated, but the result shows signs of a pressure response at the reservoir level in the data. Reflection coefficients were calculated using surface seismic data (3D and pseudo-3D) at the site. Pre-injection calculations agree well with calculations from logging data. Post-injection calculations are in general agreement with the seismic modeling, but generally show higher amplitudes than those expected. The full 3D data show a better image of the reflection coefficients before and after injection than the pseudo-3D data and can potentially be used to make quantitative calculations of CO2 volumes. The pseudo-3D data only provide qualitative information.
| Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:uu-163013 |
| Date | January 2012 |
| Creators | Yang, Can |
| Publisher | Uppsala universitet, Geofysik, Uppsala : Acta Universitatis Upsaliensis |
| Source Sets | DiVA Archive at Upsalla University |
| Language | English |
| Detected Language | English |
| Type | Doctoral thesis, comprehensive summary, info:eu-repo/semantics/doctoralThesis, text |
| Format | application/pdf |
| Rights | info:eu-repo/semantics/openAccess |
| Relation | Digital Comprehensive Summaries of Uppsala Dissertations from the Faculty of Science and Technology, 1651-6214 ; 887 |
Page generated in 0.0024 seconds