Return to search

Slim Moly S makes hydrogen : Layer dependent electrocatalysis in hydrogen evolution reaction with individual MoS2 nanodevices / Slanka Moly S gör väte : Lagerberoende elektrokatalys vid generering av väte med individuella MoS2 nanoenheter.

Molybdenum disulfide (MoS2) has been demonstrated to be a potential catalyst in the hydrogen evolution reaction (HER). Due to its highly active edge site, abundance, and low cost, it rivals Pt. However, the potential activity of the MoS2 basal plane has largely been ignored. The physical characteristics of MoS2 and its corresponding band structure change significantly with decreasing thickness, especially at the monolayer limit. Thus, an investigation on the thickness dependence may provide important insights into the MoS2 basal plane activity. In this thesis, the layer dependent electrocatalytic performance is investigated with mono-, bi- and multilayer MoS2 based individual nanodevices. Three conclusions were reached. (1) Monolayers showed exchange current densities more than one order of magnitude higher than that of the multilayers, 0.12 mA/cm2 and 8.7 mA/cm2, respectively. Furthermore, the onset potential of the monolayer was several hundred millivolts lower than that of the multilayer, about 0.2 V vs RHE for the monolayer versus 0.5 V vs RHE for the multilayer. The Tafel slope of 100-200 mV/dec revealed that the rate limiting step was the adsorption of hydrogen. (2) Interestingly, the bilayer sample exhibited an increase in its exchange current density from 0.3 mA/cm2 to 8 mA/cm2 when cycled extensively. This is suspected to be caused by intercalation of hydrogen between the atomic layers. (3) Additionally, the back-gate voltage is applied to tune the Fermi level of the material and the catalytic performance. It was found that the back-gate voltage induces an irreversible change in all samples, increasing the exchange current density by an order of magnitude. The superior basal plane performance of the monolayers to that of the multilayers reveals a new way to optimize the performance of MoS2 as a HER catalyst. In addition, the results above illuminate the yellow brick road to potential improvements in other layered materials as well.

Identiferoai:union.ndltd.org:UPSALLA1/oai:DiVA.org:uu-355025
Date January 2018
CreatorsBrischetto, Martin
PublisherUppsala universitet, Tillämpad materialvetenskap, University of Washington
Source SetsDiVA Archive at Upsalla University
LanguageEnglish
Detected LanguageEnglish
TypeStudent thesis, info:eu-repo/semantics/bachelorThesis, text
Formatapplication/pdf
Rightsinfo:eu-repo/semantics/openAccess
RelationUPTEC Q, 1401-5773 ; 18018

Page generated in 0.0078 seconds