Thesis (MTech (Chemical Engineering))--Cape Peninsula University of Technology, 2008. / Certain non-Newtonian fluids exhibit a yield stress which can be measured with a variety of
instruments varying from very sophisticated rotary and tube viscometers to hand-held slump
cones and cylinders of various sizes. Accurate yield stress measurement is significant for
process design and disposal operations for thickenend tailings. The slump value was first related
to the yield stress by Murata (1984). Later, that work was corrected by Christensen (1991) for an
error in the mathematical analysis. Slump, based on a circular cylindrical geometry was first
investigated by Chandler (1986). These concepts led to the study by Pashias et al., (1996) that
formed the basis for the current research. The Flow Process Research Centre (FPRC) at the Cape Peninsula University of Technology
developed a slump meter designed to lift the cone or cylinder vertically at controlled lifting
speeds. In addition the simple hand-held cylinder which is an adaptation of slump cones which
were originally developed by the concrete industry to determine the flowability of fresh concrete
was also used. The vane technique was used as a control. Cones and cylinders made of
stainless steel and PVC were fitted to the slump meter. The yield stresses of four non-Newtonian
fluids at different concentrations were tested in four different configurations at different lift speeds
to ascertain whether the measuring position, lift speed, slip, geometry, wall surface material, and
stability has an effect on the value of yield stress measured. The effect of different predictive
models was also ascertained.The cylinder, lump and cone models relating slump to yield stress
was used in the dimensional analysis of the results. The objective of this work was to determine if
the slump tests (cone, cylinder and the hand-held cylinder) would generate yield stress values
comparable to those found using the vane technique. It was establised that there was no significant effect of lift speed, stability, geometry and wall
surface material on the value of yield stress. The effect of measuring position on the value of
yield stress calculated gave a difference of 25%. Using dimensional analysis, the lump model
(Hallbom, 2005) more accurately predicts the material yield stress when using the hand-held
cylinder as well as all the cone results (due to its specific geometry), and cylinder configurations,
thus affirming the work of Clayton et al., 2003.
It is concluded that, although the materials and concentrations tested induced errors within 40%,
the hand-held cylinder shows promise as a reliable, quick and simple way of measuring the yield
stress.
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:cput/oai:localhost:20.500.11838/2160 |
| Date | January 2008 |
| Creators | Nyekwe, Ichegbo Maxwell |
| Contributors | Haldenwang, R, Masalova, I, Cape Peninsula University of Technology. Faculty of Engineering. Dept. of Chemical Engineering. |
| Publisher | Cape Peninsula University of Technology |
| Source Sets | South African National ETD Portal |
| Language | en_ZA |
| Detected Language | English |
| Type | Thesis |
| Rights | http://creativecommons.org/licenses/by-nc-sa/3.0/za/ |
Page generated in 0.0218 seconds