Currently at the Savannah River Site (SRS), there are fifteen single-shell, 3.6-million liter tanks containing High Level Waste. To close the tanks, the sludge must be removed. Mechanical methods have had limited success. Oxalic acid cleaning is now being considered as a new technology. This research uses sample results and chemical equilibrium software to develop a preferred flowsheet and evaluate the acceptability of the system impacts.
Based on modeling and testing, between 246,000 to 511,000 l of 8 wt% oxalic acid were required to dissolve a 9,000 liter Purex sludge heel. For SRS H-Area modified sludge, 322,000 to 511,000 l were required. To restore the pH of the treatment tank slurries, approximately 140,000 to 190,000 l of 50 wt% NaOH or 260,000 to 340,000 l of supernate were required.
When developing the flowsheet, there were two primary goals to minimize downstream impacts. The first was to ensure that the Resultant oxalate solids were transferred to DWPF, without being washed. The second was to transfer the remaining soluble sodium oxalates to the evaporator drop tank, so they do not transfer through or precipitate in the evaporator pot.
Adiabatic modeling determined the maximum possible temperature to be 73.5°C and the maximum expected temperature to be 64.6°C. At one atmosphere and at 73.5°C, a maximum of 770 l of water vapor was generated, while at 64.6°C a maximum 254 l of carbon dioxide were generated. Although tank wall corrosion was not a concern, because of the large cooling coil surface area, the corrosion induced hydrogen generation rate was calculated to be as high as 10,250 l/hr. Since the minimum tank purge exhaust was assumed to be 5,600 l/hr, the corrosion induced hydrogen generation rate was identified as a potential concern.
Excluding corrosion induced hydrogen, trending the behavior of the spiked constituents of concern, and considering conditions necessary for ignition, energetic compounds were shown not to represent an increased risk Based on modeling, about 56,800 l of Resultant oxalates could be added to a washed sludge batch with minimal impact on the number of additional glass canisters produced. For each sludge batch, with 1 to 3 heel dissolutions, about 60,000 kg of sodium oxalate entered the evaporator system, with most collecting in the drop tank, where they will remain until eventual salt heel removal. For each 6,000 kg of sodium oxalate in the drop tank, about 189,000 l of Saltstone feed would eventually be produced.
Overall, except for corrosion-induced hydrogen, there were no significant process impacts that would forbid the use of oxalic acid in cleaning High Level Waste tanks. / MATHEMATICAL SCIENCES / M. Tech. (Chemical Engineering)
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:unisa/oai:umkn-dsp01.int.unisa.ac.za:10500/2020 |
| Date | 31 March 2008 |
| Creators | Ketusky, Edward Thomas |
| Contributors | Samadi, F. R., Meyer, W., djagegjj@unisa.ac.za |
| Source Sets | South African National ETD Portal |
| Language | English |
| Detected Language | English |
| Type | Dissertation |
| Format | 1 online resource (xiv, 169 leaves) |
Page generated in 0.0087 seconds