The present thesis investigates the friction properties of total knee replacement components using lubricating fluids of different composition and rheology. The first stage of the thesis involves characterization of the rheological properties of hyaluronic acid (HA)/bovine calf serum (BCS) solutions. With increased concentration and molecular weight of HA, higher viscosities and more pronounced shear thinning in steady shear flow was observed. In dynamic oscillatory flow, the elastic character of the solutions became more pronounced and the cross-over frequency decreased upon increasing concentration and molecular weight of HA.
The second part of the thesis involves the determination of a method by which the coefficient of friction is estimated using a linear reciprocating wear testing machine with spherical metal indenters articulating on flat UHMWPE samples and deionised (D.I.) water lubrication. A characteristic periodic pattern in the friction behaviour was observed and the coefficient of friction was computed by calculating the average of 30 points about the midpoint between reversals and using the average of three cycles.
The third part of the thesis involves the investigation of the effect of fluid composition on the coefficient of friction in knee replacement components. With increased concentration of HA in solution (0-1mg/mL), the coefficient of friction of HA/BCS solutions decreased. However, with HA/BCS solutions of higher HA concentrations (above 1mg/mL), no significant difference in the coefficient of friction was observed. Similar behavior was observed with HA/Albumin solutions. With HA/ D.I. water solutions, the coefficient of friction was almost identical irrespective of the concentration of HA in solution. Significant difference in the rheological properties of HA/D.I. water solutions did not affect the coefficient of friction. The Stribeck analysis revealed that the coefficient of friction with HA/BCS and HA/D.I. water lubrication was not governed by hydrodynamic conditions.
The fourth part of this thesis involved characterization of lubricating fluids before and after friction testing. Absorbance and dynamic light scattering measurements of HA/BCS solutions and of HA/Albumin solutions indicate a rise in turbidity and the presence of larger size particles in these solutions after friction testing. The ninhydrin test confirmed the presence of protein in the precipitates obtained following testing. / Thesis (Ph.D, Chemical Engineering) -- Queen's University, 2010-09-24 14:06:41.437
| Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:OKQ.1974/6099 |
| Date | 27 September 2010 |
| Creators | FAM, Hala |
| Contributors | Queen's University (Kingston, Ont.). Theses (Queen's University (Kingston, Ont.)) |
| Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
| Language | English, English |
| Detected Language | English |
| Type | Thesis |
| Rights | This publication is made available by the authority of the copyright owner solely for the purpose of private study and research and may not be copied or reproduced except as permitted by the copyright laws without written authority from the copyright owner. |
| Relation | Canadian theses |
Page generated in 0.0018 seconds