Technological advances in physical activity measurement have increased the development and utilization of accelerometers and pedometers for assessing physical activity in controlled and free-living conditions. Individual differences in leg length, stride length and stride frequency may affect the reliability and validity of accelerometers in estimating energy expenditure. To address this theory, this thesis investigated the influence of leg length, stride length and stride frequency on accelerometer counts and energy expenditure using four accelerometers (AMP, Actical, MTI, and RT3) and one pedometer (Yamax). Eighty-six participants, age 8 to 40 (17.6 ± 8.0) years performed three ten-minute bouts of treadmill activity at self-selected speeds (4 to 12 km/h). Energy expenditure (kcal/min) was measured through expired gas analysis and used as the criterion standard to compare physical activity data from activity monitors. A 3 (models) x 2 (duplicates of each model) x 3 (speeds) x 7 (minutes) repeated measures ANOVA was used to assess intra-device, inter-device, and inter-model reliability. Coefficients of variation were calculated to compare within-device variation and between-device variation in accelerometer counts. Differences between measured and predicted energy expenditure were assessed across five height categories to determine the influence of leg length on the validity of accelerometer/pedometer data. Regression equations for each model were developed using mean activity counts/steps generated for each speed, adjusting for various predictor variables (i.e., age, weight, leg length). These were compared to model-specific equations to determine whether the addition of certain variables might explain more variance in energy expenditure. Leg length and stride frequency directly influenced variability in accelerometer data and thus predicted energy expenditure. At high speeds and stride frequencies counts began to level off in the Actical, however this did not occur in the other devices. Intra-device and inter-device variation in accelerometer counts was less than 10% and was lowest at very high speeds for the Actical, MTI, and RT3 (p<0.05). When compared to measured values, energy expenditure was consistently underestimated by the AMP, Actical, and Yamax models and consistently overestimated by the RT3 across speed. The MTI underestimated and overestimated energy expenditure depending on speed. Energy expenditure was both underestimated and overestimated to the greatest extent during the treadmill run for the tallest participants (p<0.05). Accelerometer counts or pedometer steps, when entered into regression equations with age, weight and leg length, explained from 85 to 94 % of the variance in measured energy expenditure, supporting the inclusion of these variables within manufacturer-based equations. These results suggest that individual differences in leg length and stride frequency affect the reliability and validity of accelerometer data and therefore must be controlled for when using accelerometry to predict energy expenditure.
Identifer | oai:union.ndltd.org:USASK/oai:usask.ca:etd-07222005-153945 |
Date | 25 July 2005 |
Creators | Stone, Michelle Rolande |
Contributors | Tremblay, Mark, Hall, Peter A., Drinkwater, Donald T., Binsted, Gordon |
Publisher | University of Saskatchewan |
Source Sets | University of Saskatchewan Library |
Language | English |
Detected Language | English |
Type | text |
Format | application/pdf |
Source | http://library.usask.ca/theses/available/etd-07222005-153945/ |
Rights | unrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to University of Saskatchewan or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report. |
Page generated in 0.0027 seconds