Return to search

Rheology of grout for preplaced aggregate concrete : investigation on the effect of different materials on the rheology of Portland cement based grouts and their role in the production of preplaced aggregate concrete

Preplaced aggregate concrete (PAC) is produced by grouting high workability cement based grouts among the voids of compacted coarse aggregate mass. Because of its low shrinkage, PAC has been used for many repair jobs like; tunnel lines, dams and bridge piers. Moreover, it has been used for underwater construction. Grout has a major effect on the properties of produced PAC and well defined grout controls the properties of resulted PAC. The effect of types and amount of powder materials, admixtures, sand and water content on the properties of fresh and hardened grout for the production of PAC have been investigated. Tests on hardened grout and PAC properties have also been carried out to investigate the most important effects. A correlation between hardened properties of grout and PAC has also been analyzed. Grout rheology using four different gradation sands at two different cement-sand and at different w/c ratios ratios has been identified experimentally; no added chemical admixtures or mineral additives had first employed, then superplasticizer (SP) was added at 2% and 1%, and finally a combination of 1% SP and pulverized fuel ash (Pfa) at 20% of the cement weight was employed for all mixes. Grout tests have included two point workability tests by the Viskomat NT, flow time funnel test, Colcrete flow meter test, and water bleeding test. After that, eighteen grout mixes with high workability were produced using three different sands at three w/c ratios and two c/s ratios with 1% SP and Pfa at 20% of the cement weight were designed. Eighteen hardened grout and PAC then produced and their compressive strength and sorptivity were tested. Grout rheology can be defined by the rheology of cement paste employed and the internal distance between sand particles. The effect of sand surface texture on grout rheology is important at very low internal distances. Fresh grout yield stress is the most important property which gives the same degree of sensitivity for all grouts regardless the material type and content used in the mix. There are strong relations between compressive strength of grout and PAC, but less correlation between them in sorptivity test because of the effect high quantity of coarse aggregate of PAC. Sorptivity of PAC is low comparing with different kinds of concrete suggesting its advantage for underwater construction.

Identiferoai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:583017
Date January 2012
CreatorsGanaw, Abdelhamed I.
ContributorsHughes, David C.; Ashour, Ashraf F.
PublisherUniversity of Bradford
Source SetsEthos UK
Detected LanguageEnglish
TypeElectronic Thesis or Dissertation
Sourcehttp://hdl.handle.net/10454/5766

Page generated in 0.0013 seconds