Designing CMOS linear transmitter front-end, specially the power amplifiers (PAs), in multi-band wireless transceivers is a major challenge for the single-chip integration of a CMOS radio. In some of the linear PA systems, for example, polar- or predistortion-PA system, amplitude and phase control circuits are used to suppress the distortion produces by the PA core. The requirements of these controlling circuits are much different from their conventional role in a receiver or a phase array system. In this dissertation, the special design issues will be addressed, and the circuit topologies of the amplitude and phase controllers will be proposed.
In attempt to control the high-power input signal of a PA system, a highly linear variable attenuator with adaptive body biasing is first introduced. The voltage swing on the signal path is intentionally coupled to the body terminal of the triple-well NMOS devices to reduce their impedance variation. The fabricated variable attenuator shows a significant improvement on linearity as compared to previous CMOS works. The results of this research are then used to build a variable gain amplifier for linear PA systems that requires gain of its amplitude tuning circuits. Different from the conventional attenuator-based VGAs, the high linearity of the suggested attenuator allows it to be put after the gain stage in the presented VGA topology. This arrangement along with the current boosting technique gives the VGA a better noise performance while having a linear-in-dB tuning curve and better worst-case linearity.
The following part of the dissertation is about a compact, linear-in-degree tuned variable phase shifter as the phase controller in the PA system. This design uses a modified RC poly-phase filter to produce a set of an orthogonal phase vectors with smaller loss. A specially designed control circuit combines these vectors and generates an output signal with different phases, while having very small gain mismatches at different phase setting. The proposed amplitude and phase control circuits are then verified with a system level analysis. The results show that the proposed designs successfully reduce the non-linear effect of a wireless transmitter.
Identifer | oai:union.ndltd.org:GATECH/oai:smartech.gatech.edu:1853/44908 |
Date | 05 July 2011 |
Creators | Huang, Yan-Yu |
Publisher | Georgia Institute of Technology |
Source Sets | Georgia Tech Electronic Thesis and Dissertation Archive |
Detected Language | English |
Type | Dissertation |
Page generated in 0.0022 seconds