The air kerma area product PKA is an important quantity used by hospital physicists in quality assurance and optimization processes in diagnostic radiology and is recommended by national authorities for setting of diagnostic reference levels. PKA can be measured using a transmission ionization chamber (kerma area product (KAP) meter) mounted on the collimator housing. Its signal QKAP must be calibrated to give values of PKA. The objective of this thesis is to analyze the factors influencing the accuracy of the calibration coefficients k= PKA/QKAP and of reported PKA-values. Due to attenuation and scatter in the KAP-meter and presence of extra-focal radiation, values of PKA depend on the choice of integration area A and the distance of the reference plane from the focal spot yielding values of PKA that may differ by as much as 23% depending on this choice. The two extremes correspond to (1) PKA=PKA,o integrated over the exit surface of the KAP-meter resulting in geometry independent calibration coefficients and (2) PKA=PKA,Anom integrated over the nominal beam area in the patient entrance plane resulting in geometry dependent calibration coefficients. Three calibration methods are analysed. Method 1 aims at determine PKA,Anom, for clinical use at the patient entrance plane. At standard laboratories, the method is used to calibrate with respect to radiation incident on the KAP-meter. Problems with extra-focal and scattered radiation are then avoided resulting in calibration coefficients with low standard uncertainty (±1.5 %, coverage factor 2). Method 2 was designed in this work to approach determination of PKA,o using thermoluminescent detectors to monitor contributions from extra-focal radiation and account for the heel effect. The uncertainty in derived calibration coefficients was ± 3% (coverage factor 2). Method 3 uses a Master KAP-meter calibrated at a standard laboratory for incident radiation to calibrate clinical KAP-meters. It has potential to become the standard method in the future replacing the tedious method 2 for calibrations aiming at determination of PKA,o. Commercially available KAP-meters use conducting layers of indium oxide causing a strong energy dependence of their calibration coefficients. This dependence is investigated using Monte Carlo simulations and measurements. It may introduce substantial uncertainties in reported PKA– values since calibration coefficients as obtained from standard laboratories are often available only at one filtration (2.5 mm Al) as function of tube voltage or HVL. This is not sufficient since higher filtrations are commonly used in practice, including filters of Cu. In extreme cases, calibration coefficients for the same value of HVL but using different tube voltages and filtrations can deviate by as much as 30%. If standardised calibration methods are not used and choice of calibration coefficients not carefully chosen with respect to beam quality, the total uncertainty in reported PKA–values may be as large as 40-45%. Conversion of PKA-values to risk related quantities is briefly discussed. The large energy dependence of the conversion coefficients, ε/PKA, for determination of energy imparted,ε, to the patient reduces to a lower energy dependence of calibration coefficients CQ,ε = ε/QKAP for determination of ε from the KAP-meter signal.
Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:liu-7848 |
Date | January 2006 |
Creators | Larsson, Peter |
Publisher | Linköpings universitet, Medicinsk radiofysik, Linköpings universitet, Hälsouniversitetet, Institutionen för medicin och vård |
Source Sets | DiVA Archive at Upsalla University |
Language | English |
Detected Language | English |
Type | Doctoral thesis, comprehensive summary, info:eu-repo/semantics/doctoralThesis, text |
Format | application/pdf |
Rights | info:eu-repo/semantics/openAccess |
Relation | Linköping University Medical Dissertations, 0345-0082 ; 970 |
Page generated in 0.0019 seconds