M.Ing. (Electrical and Electronic Engineering) / In this study, the problem of correcting burst of adjacent deletions by adapting product codes was investigated. The first step in any digital transmission is to establish synchronization between the sending and receiving nodes. This initial synchronization ensures that the receiver samples the information bits at the correct interval. Unfortunately synchronization is not guaranteed to last for the entire duration of data transmission. Though synchronization errors rarely occur, it has disastrous effects at the receiving end of transmission. These synchronization errors are modelled as either insertions or deletions in the transmitted data. In the best case scenario, these errors are restricted to single bit errors. In the worst case scenario, these errors lead to bursts of bits being incorrect. If these synchronization errors are not detected and corrected, it can cause a shift in the transmitted sequence which in turn leads to loss of synchronization. When a signal is subjected to synchronization errors it is difficult accurately recover the original data signal. In addition to the loss of synchronization, the information transmitted over the channel is also subjected to noise. This noise in the channel causes inversion errors within the signal. The objective of this dissertation is to investigate if an error correction scheme can be designed that has the ability to detect and correct adjacent bursts of deletions and random inversion errors. This error correction scheme needed to make use of a product code matrix structure. This product matrix needed to incorporate both an error correction and synchronization technique. The chosen error correcting techniques were Hamming and Reed-Solomon codes. The chosen synchronization techniques for this project were the marker technique or an adaptation of the Hamming code technique. In order to find an effective model, combinations of these models were simulated and compared. From the research obtained and analyzed in this document it was found that, depending on the desired performance, complexity and code rate, an error correction scheme can be used in the efficient correction of bursts of adjacent deletions by adapting product codes.
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:uj/uj:13517 |
| Date | 25 March 2015 |
| Source Sets | South African National ETD Portal |
| Detected Language | English |
| Type | Thesis |
| Rights | University of Johannesburg |
Page generated in 0.0024 seconds