The performance of joints in buried gravity flow pipelines are important since failure of these elements can affect the structural capacity of soil-pipe systems and reduce their longevity. Currently, there are no clear guidelines to design joints for gravity flow pipelines and therefore their design is based on semi-empirical methods. It is necessary to identify and quantify the demands that act across joints when subjected to service loading conditions to establish adequate design guidelines. Such demands will vary depending on the type of joint, type of pipe, burial and loading conditions. Therefore work is needed to investigate the influence of these conditions on the performance of joints.
Full-scale laboratory tests have been performed on rigid (reinforced concrete) and flexible (corrugated steel and thermoplastic) pipelines to investigate the response of their joints when buried and subjected to surface loading. The joints investigated are either ‘moment-release’ joints (those that accommodate rotation and reduce the longitudinal bending moments close to zero), or ‘moment-transfer’ joints (those that limit rotation and transfer longitudinal bending moments from one pipe to the next). These experiments evaluate the influence of different cover depths, loading locations, and installation conditions on the response of the joints. Additionally, the performance of each joint when the pipeline was buried with shallow cover and subjected to surface loads up to and beyond fully factored loads were also investigated. Furthermore, three-dimensional finite element analyses of a gasketed bell and spigot joint in a buried reinforced concrete pipeline subjected to surface loading have been developed employing material properties and joint rotational characteristics experimentally obtained.
The data obtained from the experimental and computational studies are used to evaluate joint performance and to identify key demands (shear force and rotation or moment) acting across them. In addition, the different patterns of vertical displacement along rigid and flexible pipes were established. It was found that the stiffness of the pipeline, the geometry of the joint, the loading and burial conditions influence the response (and therefore the demands) of the joints examined. Finally, recommendations are provided regarding development of structural design methods for these pipeline and joint systems. / Thesis (Ph.D, Civil Engineering) -- Queen's University, 2012-12-29 12:47:31.826
| Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:OKQ.1974/7702 |
| Date | 02 January 2013 |
| Creators | Becerril García, DAVID |
| Contributors | Queen's University (Kingston, Ont.). Theses (Queen's University (Kingston, Ont.)) |
| Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
| Language | English, English |
| Detected Language | English |
| Type | Thesis |
| Rights | This publication is made available by the authority of the copyright owner solely for the purpose of private study and research and may not be copied or reproduced except as permitted by the copyright laws without written authority from the copyright owner. |
| Relation | Canadian theses |
Page generated in 0.0018 seconds