This work was performed as part of an EPSRC Leadership Fellowship [EP/I005420/1] for the study of irradiation damage in Zr alloys, and is supported heavily by industrial contributors and especially by Westinghouse, Studsvik and Rolls-Royce plc. for the investigation of mechanisms relating to irradiation-induced growth (IIG). This thesis is an analysis of the microchemical and microstructural evolution of Zircaloy-2 under both proton and neutron irradiation. Comparisons are made between the effects of the different irradiative species through the use of scanning transmission electron microscopy (STEM) and energy dispersive X-ray spectroscopy (EDS). The work takes advantage of advances in EDS capability with large solid angles of collection 0.7 srad coupled with an aberration-corrected FEI Titan ChemiSTEMTM with a high brightness X-FEG electron source.2 MeV proton irradiation experiments were performed to doses of 2.3, 4.7 and 7.0 displacements per atom (dpa) at a dose rate of ~6.7 x10-6 dpa s-1 and at 350 °C. Electropolished TEM foils from Zircaloy-2 cladding and channel components of a BWR were supplied by Westinghouse in the fluence range 8.7 to 14.7 x1025 n m-2 ~14.5 to 24.5 dpa. Comparisons have been made in relation to SPP chemical composition, grain boundary chemistry, dislocation density, correlations between dislocation evolution and microchemical segregations and the nature of irradiation-induced precipitates. Proton irradiation-induced dissolution was observed for both Zr(Fe,Cr)2 and Zr2(Fe,Ni) SPPs, the depletion of Fe was preferentially from the edge region in the former SPP and from throughout the whole SPP in the latter. While no proton-induced amorphisation was observed for the Zr(Fe,Cr)2, the compositional changes in all SPPs agreed well with the reports of other authors. All grain boundaries display Fe and Ni segregation prior to irradiation, which disperses into the matrix after both proton and neutron irradiation, while Sn segregates to the boundary. Sn and the light transition elements Fe, Cr and Ni have shown contrasting behaviour in the matrix also. After irradiation by both protons and neutrons, a-component dislocation loops (a-loops) align parallel to the basal plane and Fe, Cr and Ni segregate to the a-loop positions. Sn, conversely, segregates to between a-loop positions parallel to the basal trace. The threshold dose in c-component dislocation loop (c-loop) nucleation under proton irradiation (~4.5 dpa) is shown as similar to that due to neutron irradiation (~5 dpa). We observe that a-loop density decreases at the onset of c-loop nucleation and that the position of c-loops are in alignment with the a-loops but that they are anticorrelated in position along the basal trace. We therefore propose that chemical ordering promotes the alignment of a-loops, which then provides the conditions necessary for c-loop nucleation. Nanoprecipitation is evident in the matrix after both proton and neutron irradiation. After proton irradiation to ~2 dpa, parallel atom probe tomography and STEM-EDS investigations have shown the nano-rods to be of composition Zr4(Fe0.67Cr0.33), tending towards Zr3(Fe0.69Cr0.31) as the rod volume increases. The rods are higher in density than the a-loops by a factor of ~3 and so are likely to be a significant influence on mechanical properties and IIG phenomena.
| Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:722279 |
| Date | January 2016 |
| Creators | Harte, Allan |
| Contributors | Preuss, Michael |
| Publisher | University of Manchester |
| Source Sets | Ethos UK |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Source | https://www.research.manchester.ac.uk/portal/en/theses/a-comparison-of-proton-and-neutron-irradiationinduced-microstructural-and-microchemical-evolution-in-zircaloy2(69794542-8d75-402f-ae09-b21e43d2a538).html |
Page generated in 0.002 seconds