This experimental study consists of two parts. For the first part, the film cooling effectiveness for a single row of seven cylindrical holes with a compound angle is measured on a flat surface using five different measurement techniques: steady-state liquid crystal thermography, transient liquid crystal thermography, pressure sensitive paint (PSP), thermocouples, and infrared thermography. A comparison of the film cooling effectiveness from each of the measurement techniques is presented. All methods show a good comparison, especially for the higher blowing ratios. The PSP technique shows the most accurate measurements and has more advantages for measuring film cooling effectiveness. Also, the effect of blowing ratio on the film cooling effectiveness is investigated for each of the measurement techniques.
The second part of the study investigates the effect of hole geometries on the film cooling effectiveness using pressure sensitive paint. Nitrogen is injected as the coolant air so that the oxygen concentration levels can be obtained for the test surface. The film effectiveness is then obtained by the mass transfer analogy. Five total hole geometries are tested: fan-shaped laidback with a compound angle, fan-shaped laidback with a simple angle, a conical configuration with a compound angle, a conical configuration with a simple angle, and the reference geometry (cylindrical holes) used in part one. The effect of blowing ratio on film cooling effectiveness is presented for each hole geometry. The spanwise averaged effectiveness for each geometry is also presented to compare the geometry effect on film cooling effectiveness. The geometry of the holes has little effect on the effectiveness at low blowing ratios. The laterally expanded holes show improved effectiveness at higher blowing ratios.
All experiments are performed in a low speed wind tunnel with a mainstream velocity of 34 m/s. The coolant air is injected through the coolant holes at four different coolant-to-mainstream velocity ratios: 0.3, 0.6, 1.2, and 1.8.
| Identifer | oai:union.ndltd.org:tamu.edu/oai:repository.tamu.edu:1969.1/1524 |
| Date | 17 February 2005 |
| Creators | Varvel, Trent Alan |
| Contributors | Han, Je-Chin |
| Publisher | Texas A&M University |
| Source Sets | Texas A and M University |
| Language | en_US |
| Detected Language | English |
| Type | Book, Thesis, Electronic Thesis, text |
| Format | 1105806 bytes, electronic, application/pdf, born digital |
Page generated in 0.0013 seconds