No / Transient liquid phase (TLP) brazing of Mg–AZ31 alloy and Ti–6Al–4V alloy was performed using double Ni and Cu sandwich foils. Two configurations were tested; first, Mg–AZ31/Cu–Ni/Ti–6Al–4V and second, Mg–AZ31/Ni–Cu/Ti–6Al–4V. The effect of set-up configuration of the foils on microstructural developments, mechanical properties and mechanism of joint formation was examined. The results showed that different reaction layers formed inside the joint region depending on the configuration chosen. The formation of e phase (Mg), r (CuMg2), d (Mg2Ni) and Mg3AlNi2 was observed in both configurations. Maximum shear strength obtained was 57 MPa for Mg–AZ31/Ni–Cu/Ti–6Al–4V configuration and in both configurations, the increase in bonding time resulted in a decrease in joint strength to 13 MPa. The mechanism of joint formation includes three stages; solid state diffusion, dissolution and widening of the joint, and isothermal solidification. / The authors would like to acknowledge The German Jordanian University (GJU), and NSERC Canada for the financial support for this research.
Identifer | oai:union.ndltd.org:BRADFORD/oai:bradscholars.brad.ac.uk:10454/11602 |
Date | 21 February 2014 |
Creators | Atieh, A.M., Khan, Tahir I. |
Source Sets | Bradford Scholars |
Language | English |
Detected Language | English |
Type | Article, No full-text in the repository |
Rights | © 2014 Taylor & Francis. This is an Accepted Manuscript of an article published by Taylor & Francis Group in Science and Technology of Welding and Joining on 21/02/2014, available online: http://www.tandfonline.com/10.1179/1362171814Y.0000000196 |
Page generated in 0.0016 seconds