Thin-film silicon photovoltaics are seen as a good possibility for reducing the cost of solar electricity. The focus of this thesis is the ALICIA cell, a thin-film polycrystalline silicon solar cell made on a glass superstrate. The name ALICIA comes from the fabrication steps - ALuminium Induced Crystallisation, Ion Assisted deposition. The concept is to form a high-quality crystalline silicon layer on glass by Aluminium Induced Crystallisation (AIC). This is then the template from which to epitaxially grow the solar cell structure by Ion Assisted Deposition (IAD). IAD allows high-rate silicon epitaxy at low temperatures compatible with glass. In thin-film solar cells, light trapping is critical to increase the absorption of the solar spectrum. ALICIA cells have been fabricated on textured glass sheets, increasing light absorption due to their anti-reflection nature and light trapping properties. A 1.8 μm thick textured ALICIA cell absorbs 55% of the AM1.5G spectrum without a back-surface reflector, or 76% with an optimal reflector. Experimentally, Pigmented Diffuse Reflectors (PDRs) have been shown to be the best reflector. These highly reflective and optically diffuse materials increase the light-trapping potential and hence the short-circuit currents of ALICIA cells. In textured cells, the current increased by almost 30% compared to using a simple aluminium reflector. Current densities up to 13.7 mA/cm2 were achieved by application of a PDR to the best ALICIA cells. The electronic quality of the absorber layer of ALICIA cells is strongly determined by the epitaxy process. Very high-rate epitaxial growth decreases the crystalline quality of the epitaxial layer, but nevertheless increases the short-circuit current density of the solar cells. This indicates that the diffusion length in the absorber layer of the ALICIA cell is primarily limited by contamination, not crystal quality. Further gains in current density can therefore be achieved by increasing the deposition rate of the absorber layer, or by improving the vacuum quality. Large-area ALICIA cells were then fabricated, and series resistance reduced by using an interdigitated metallisation scheme. The best measured efficiency was 2.65%, with considerable efficiency gains still possible from optimisation of the epitaxial growth and metallisation processes.
| Identifer | oai:union.ndltd.org:ADTP/258432 |
| Date | January 2007 |
| Creators | Inns, Daniel, Photovoltaics & Renewable Energy Engineering, Faculty of Engineering, UNSW |
| Publisher | Publisher:University of New South Wales. Photovoltaics & Renewable Energy Engineering |
| Source Sets | Australiasian Digital Theses Program |
| Language | English |
| Detected Language | English |
| Rights | http://unsworks.unsw.edu.au/copyright, http://unsworks.unsw.edu.au/copyright |
Page generated in 0.002 seconds