The challenge of demolding during the cast molding process of silicone hydrogel contact lenses can be addressed with the application of hydrophobic coatings on the surface of lens mold. In particular, the adhesion between silicone hydrogel and silicate substrates was minimized by applying silane modification on the surface of silicate substrates. Peel tests were conducted to measure the adhesive strengths between silicone hydrogel and surface modified glass substrates. Water contact angle measurement and X-ray photoelectron spectroscopy (XPS) were utilized to characterize the surface properties of silane treated glass substrates.Silicone hydrogel was obtained by curing macromer mixture under UV for 6 minutes, with UV intensity of 95.0 mW/cm2. The obtained silicone hydrogel had a modulus of 0.87±0.09 MPa, within the same range of commercial contact lenses. And the hydrogel with a UV curing time of 6 minutes was unable to be peeled off from clean glass substrates. The effects of silane type and concentration on coating effectiveness were investigated and the most effective types of silane were found to be triethoxyphenylsilane (TEPhS) and octyltriethoxysilane (OTES), with an optimal concentration of 5 wt%. The peel strength between silicone hydrogel and silicate substrates was reduced to below 15.5 N/m with the application of TEPhS and OTES coatings. However, these silane coatings were not durable enough. Silane coupling agents need to be reapplied before each curing process of silicone hydrogel. / Thesis / Master of Applied Science (MASc)
| Identifer | oai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/18986 |
| Date | January 2016 |
| Creators | Liu, Chang Jr |
| Contributors | Pelton, Robert Jr, Chemical Engineering |
| Source Sets | McMaster University |
| Language | English |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0022 seconds