Return to search

Seismic Rehabilitation of RC Structural Walls

<p>Structural walls in existing buildings designed to pre 1970s codes may have deficient shear reinforcement and lap splice detailing. Lap splices at the bottom of the walls were designed in compression with anchorage length of 24-bar diameter. When the structural wall is subjected to lateral loads during a major seismic event, the lap splice is in the zone of maximum moment and shear and may be subjected to tension. Such design may cause nonductile behaviour and sudden failure of the wall due to shear or bond slip of the lap splice reinforcing bars. The effect of shear and ductility rehabilitation on the behaviour of reinforced concrete structural walls, without lap splice, have shown improvement in the structural wall shear resistance and ductility and hence overall structural ductility and seismic loads resistance. Research on rehabilitation of reinforced concrete (RC) structural walls with both deficient shear reinforcement and lap splice detailing is still needed. </p> <p> The principal objectives of this study were to evaluate the seismic behaviour of non-ductile reinforced concrete structural walls before and after rehabilitation using carbon fibre reinforced polymers (CFRP). These objectives were achieved through experimental and analytical investigations.</p> <p> The experimental phase of this research involved testing large scale models of RC structural walls with deficient shear strength and lap splice detailing to reproduce failure modes observed following major seismic events and to evaluate the rehabilitation schemes. Ten RC structural walls were built and tested under cyclic loading. Three control walls were tested as-built with non-ductile detailing and seven walls were rehabilitated before testing. The purpose of the rehabilitation techniques was to prevent brittle failure in shear or bond slip and to improve the ductility and energy dissipation of RC structural walls.</p> <p> The analytical phase of this study involved evaluation of the inelastic dynamic response of
RC residential building with nonductile structural walls as well as retrofitted walls. An efficient macroscopic model to represent the behaviour of RC structural walls when subjected to pushover, cyclic and dynamic seismic loads was developed. The proposed model was intended to adequately describe the hysteretic behaviour of walls and to be capable of accurately predicting both flexural and shear components of inelastic deformation. The model predictions were compared with the experimental results. The comparisons showed that the developed analytical model predicted the inelastic walls response with a good accuracy. The analytical model was capable to evaluate the nonlinear dynamic behaviour of an existing building under seismic excitation before and after rehabilitation.</p> / Thesis / Doctor of Philosophy (PhD)

Identiferoai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/16636
Date January 2008
CreatorsElnady , Mohamed Mohamed Ebrahim
ContributorsGhobarah, Ahmed, Civil Engineering
Source SetsMcMaster University
LanguageEnglish
Detected LanguageEnglish
TypeThesis

Page generated in 0.0021 seconds