Return to search

Transmutation of Am in sodium fast reactors and accelerator driven systems

In this thesis, the feasibility to use sodium cooled fast reactors loaded with MOX, metallic and nitride fuels for efficient transmutation of americium is investigated by performing transient analysis for cases with different americium contents in fuels, using safety parameters obtained with the SERPENT Monte Carlo code. It was then demonstrated that there is no solid limit for the Am introduction into oxide, metallic and nitride fuels that were loaded into sodium fast reactors. Instead, higher Am contents could be permitted if specific levels of power penalty were accepted. Transient analysis of a new Accelerator Driven System design with higher neutron source efficiency than the reference EFIT-400 design, was also performed. Based on simulation results, the suggested ADS design was proved to survive the full set of transients, preserving 130 K margin to cladding rupture during the most limiting transient. After comparing Am transmutation performances in SFRs and the suggested ADS, it can be concluded that: 1. Nitride fuel could provide the highest Am transmutation efficiency, when loaded into SFRs; 2. One SFR loaded with nitride fuel is sufficient to transmute Am inventory produced by more than 15 commercial LWRs within the same time period, which is three times higher than the supporting ratio reported for the suggested ADS; 3. The total fraction of ADS power in the power park is half of cases for critical reactors. / QC 20120201

Identiferoai:union.ndltd.org:UPSALLA1/oai:DiVA.org:kth-72427
Date January 2012
CreatorsZhang, Youpeng
PublisherKTH, Reaktorfysik, Stockholm
Source SetsDiVA Archive at Upsalla University
LanguageEnglish
Detected LanguageEnglish
TypeDoctoral thesis, comprehensive summary, info:eu-repo/semantics/doctoralThesis, text
Formatapplication/pdf
Rightsinfo:eu-repo/semantics/openAccess
RelationTrita-FYS, 0280-316X ; 2012:05

Page generated in 0.002 seconds