The reliable operation of Integrally Geared Centrifugal Compressors (IGCCs), used in the coal-fired power generation industry of South Africa, is essential for economic, environmental and safety considerations. However, due to the unavailability of individual stage performance curves, the ability of a compressor owner to identify underperforming stages to maintain these compressors proactively remains limited.
This study addresses the stage performance prediction of an IGCC when only the compressor’s overall performance characteristic, in conjunction with the impeller diameters and tip speeds, are known. The study is limited to IGCCs used in the coal-fired power generation industry of South Africa.
Based on the limited inputs, two performance modelling methods were considered for this application, namely stage stacking and 1-dimensional modelling. However, stage stacking requires known operating points on each stage performance curve from which the rest of the curve can be extrapolated while 1-dimensional models require detailed stage design information to model stage performance.
This study developed a revised stage stacking procedure which in contrast to the traditional stage stacking procedure, does not require a known operating point on each stage’s performance curve, for it assesses the relative stage performance at the compressor’s surge flow rate. The relative maximum pressure ratio of each stage is acquired through the application of similarity principles while a simplified 1-dimensional impeller analysis model is used to assess relative impeller head coefficients.
The modelling process was developed based on performance and design data for IGCCs obtained from a compressor manufacturer. Performance data of four IGCCs, consisting of 13 stages, were obtained, including the design data for ten impellers.
Hence, the IGCCs satisfy the requirements of geometric and aerodynamic similarity, unveiling a linear relationship between the stage impeller tip speed and maximum pressure ratio. A simplified 1-dimensional performance model was used to assess relative impeller head coefficients. A verification procedure ensured the integrity of the findings of the 1-dimensional model was maintained by comparing the model results to findings obtained using commercial compressor performance modelling software. A sensitivity analysis was conducted on the 1-dimensional performance model to ascertain which input parameters could be scaled as a function of the impeller tip diameter.
For the four IGCCs for which data were obtained, the stage-discharge pressure and isentropic efficiency curves were calculated using the developed model. The maximum variation between the measured and calculated pressure and isentropic efficiency curves equaled 8.20% and 10.84%, respectively. The prediction accuracy of the developed modelling procedure is similar to map-based models found in literature and is considered adequate for identifying an underperforming stage. Thus, the developed model could serve as a valuable conditioning monitoring tool for site-based compressor owners. / Dissertation (MEng)--University of Pretoria, 2019. / Mechanical and Aeronautical Engineering / MEng / Unrestricted
Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:up/oai:repository.up.ac.za:2263/79588 |
Date | January 2019 |
Creators | Human, Dirk Cornelius |
Contributors | Mahmood, Gazi I., u28053347@tuks.co.za, Van der Spuy, Johan |
Publisher | University of Pretoria |
Source Sets | South African National ETD Portal |
Language | English |
Detected Language | English |
Type | Dissertation |
Rights | © 2020 University of Pretoria. All rights reserved. The copyright in this work vests in the University of Pretoria. No part of this work may be reproduced or transmitted in any form or by any means, without the prior written permission of the University of Pretoria. |
Page generated in 0.0021 seconds