Yes / This paper proposes a new design concept for a steel truss-reinforced concrete box girder which incorporates a steel truss instead of longitudinal bars and stirrups. A comprehensive assessment of the flexural and shear behavior of the proposed steel truss-reinforced concrete box girders was conducted through the testing of twelve girders until failure. All test specimens had the same concrete depth and width of 400 mm and 300 mm, but the length of concrete in the shear and flexural specimens were 3300 mm and 3100 mm, respectively. Moreover, the reinforcing steel truss configuration and member sizes were different. The effects of the angle steel size of the lower chord, vertical webs spacing, shear span ratio and presence of diagonal webs on the cracking, yield and ultimate loads, crack patterns, failure modes, vertical load-deflection curves and strain distribution of these steel truss-reinforced concrete box girders were studied. The test results showed that the flexural capacity of the steel truss-reinforced concrete box girder increases with the increase of angle steel size of the lower chord. Moreover, the spacing of vertical webs and presence of diagonal webs have little effect on the flexural capacity of steel truss-reinforced concrete box girders tested. With the decrease of the shear span ratio and vertical webs spacing, the shear capacity of the steel truss-reinforced concrete box girder increases. Finally, simplified formulae for calculating the flexural and shear capacities of steel truss-reinforced concrete box girders were proposed, showing good agreement with the experimental results.
| Identifer | oai:union.ndltd.org:BRADFORD/oai:bradscholars.brad.ac.uk:10454/19941 |
| Date | 26 July 2024 |
| Creators | Xue, H., Ashour, Ashraf, Ge, W., Cao, D., Sun, C. |
| Source Sets | Bradford Scholars |
| Language | English |
| Detected Language | English |
| Type | Article, Accepted manuscript |
| Rights | CC-BY-NC-ND |
Page generated in 0.0025 seconds