Recent studies have shown that, in a sufficiently deep gas-solid fluidized bed of Geldart A particles, gas streaming may occur allowing gas to bypass a large portion of the particle bed. Since this is a newly observed phenomenon in fluidized beds, there is uncertainty and lack of information about the various aspects of the streaming flow. The objective of the current project is to investigate the streaming phenomenon with a combination of experimentation and modeling. In the experimental part, pressure fluctuations as a measure of the fluidized bed hydrodynamics were used to study the influence of different parameters on the behavior of a deep fluidized bed. Pressure fluctuations have been measured at 8 axial locations from 4 to 150 cm above the gas distributor for bed depths and gas velocities ranging from 0.4 to 1.6 m and 0.04 to 0.20 m/s (equal to 10 to 50 times minimum fluidization velocity), respectively. Two particle size distributions with Sauter mean diameters of 48 µm and 84 µm and two distributor plates with differing percentage open area were also tested for each bed depth and gas velocity. Analysis of pressure fluctuations in the time and frequency domains, in combination with visual observations revealed that streaming flow emerges gradually at bed depths greater than 1 m. Increased gas velocity and fines content act to delay the onset of streaming, but can not completely eliminate it over the range of velocities examined. The two different distributor designs had no measurable effect on the streaming flow. The results of this study are provided in the first section of the present report.<p>
In order to further investigate the nature of streaming flow, several cases of forced streams and jetting flows were designed and conducted, in addition to the natural streaming flow in deep beds. Results indicated that the natural streaming most closely resembles the imposed stream which not only the imposed stream, but additional gas added through the distributor. The case of jet flows with no additional gas resembles the severe streaming that might happen in very deep beds with the existence of completely non-fluidized regions. Application of supporting jets in addition to the main gas flow could enhance the fluidization quality to some extent, however, not enough to provide a normal fluidization. Wavelet analysis of the pressure fluctuations showed that in deep fluidized beds, bubbling activity with the typical dominant frequency coexist with the streaming flow, with a minor contribution. Wavelet findings suggested that the streaming flow can be considered to form by increasing the relative importance of one available stream of bubble activity with increasing bed depth. The results of this study are provided in the second section of this report.
Further study of the streaming flow was undertaken with computational fluid dynamic (CFD) simulation of the deep fluidized bed. CFD simulation of fine Geldart A particles has met with challenges in the open literature and various modifications have been proposed to be able to model fluidized beds of these particles. In the present work, the commercial CFD codes FLUENT and MFIX were initially tested for the modeling of deep fluidized bed of Geldart A particles. However, simulation results did not show any sign of streaming flow in the fluidized bed. Subsequently, the commercial CFD code BARRACUDATM that has been claimed by the developers to be appropriate for this purpose, was tested. Due to the lack of data on the performance of this code, a simple case of modeling a freely bubbling fluidized bed of Geldart A particles was attempted first. For this purpose, four different simulation cases, which included three different numerical grid sizes and two drag models with a realistic particle size distribution were designed and tested. The simulated bed expansion, bubble size distribution, rise velocity and solid fraction were compared with commonly accepted correlations and experimental data from the literature. The results showed a promising predictive capability of the code without the need for modifying the drag model or other constitutive relations of the model. The third section of the report presents the simulation results of this study.<p>
The BARRACUDA code was then used for simulating the deep fluidized bed of Geldart A particles. However, similar to the previous CFD codes tested, instead of streaming flow, bubbling fluidization was predicted. Therefore, a phenomenological model was developed to better understand the streaming flow. According to the model results, the stream represents a zone of much lower pressure drop compared to other parts of the bed, which can be a possible reason for the formation and stability of the streaming flow inside the fluidized bed. The model results showed that increasing the bed depth enhances the streaming flow, while increasing the gas velocity improves the uniformity of the bed and decreases the streaming severity. Streaming flow was found to be less severe for larger particle sizes. All of these trends are in conformity with the experimental results. These findings provide the content of the fourth and final section of this report.
| Identifer | oai:union.ndltd.org:USASK/oai:usask.ca:etd-07272010-185853 |
| Date | 28 July 2010 |
| Creators | Karimipour, Shayan |
| Contributors | Hill, Gordon, Phoenix, Aaron, Johanson, Robert, Issangya, Allan, Nemati, Mehdi, Pugsley, Todd |
| Publisher | University of Saskatchewan |
| Source Sets | University of Saskatchewan Library |
| Language | English |
| Detected Language | English |
| Type | text |
| Format | application/pdf |
| Source | http://library.usask.ca/theses/available/etd-07272010-185853/ |
| Rights | unrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to University of Saskatchewan or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report. |
Page generated in 0.0019 seconds