Structures made of plate-like components are common in a variety of industries where the impacts of structural failures are severe. In many cases these structures are surrounded and only partially accessible, such as storage tanks and bridges, making them difficult to inspect frequently. The application of ultrasonic Guided Waves (GWs) in the evaluation and monitoring of relatively large plate-like structures is evermore a feasible option with the continuous development of transducer arrays. The use of transducer arrays is however complex due to directional control and the existence of many GW modes. Aimed at the evaluation of plate-like structures, in this research two piezoelectric transducer arrays respectively capable of omnidirectional and unidirectional control of the fundamental GW shear mode in plates (SH0) with above 20 dB mode purity are successfully designed, produced and validated. Omnidirectionality facilitates full structural evaluation coverage and can lead to defect mapping of large volumes with relatively few transducers. A unidirectional beam with relatively high mode purity facilitates evaluation of specific structural locations. Preference to the SH0 mode was given because of its non-dispersive and in-plane propagation properties making it more suitable than other GW modes to propagation in structures surrounded by fluid material. To enable the array development, a number of monolithic piezoelectric thickness-shear transducers of varied area were characterised with respect to GW mode directionality, amplitude and SH0 mode purity. The characterisation of each thickness-shear transducer allows for optimised superposition manipulation for specific applications. A single characterised shear transducer was selected for use in the development of omnidirectional and unidirectional SH0 mode transducer arrays. To aid development a linear superposition analysis model was produced and used to predict for a circular array design the optimum parameters for omnidirectional SH0 mode transmission with significant mode purity. A range of parameter combinations were evaluated and their predicted influence on array performance was characterised. The same method was employed to optimise a dual row linear array design for the unidirectional transducer array. All results were validated by FE models and later with empirical data. Both developed transducer arrays were characterised with respect to GW mode directionality, magnitude and SH0 mode purity. Both their detection sensitivity to pertinent defects and structures was validated, demonstrating relevance to Non Destructive Evaluation (NDE) and Structural Health Monitoring (SHM) applications.
| Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:764793 |
| Date | January 2016 |
| Creators | Rodrigues Marques, Hugo |
| Contributors | Haig, A. |
| Publisher | Brunel University |
| Source Sets | Ethos UK |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Source | http://bura.brunel.ac.uk/handle/2438/14021 |
Page generated in 0.0024 seconds