The Compact Linear Fresnel Reflector is a solar thermal energy system currently at prototype stage in Australia. The system uses parallel rows of mirrors lined up underneath a long, elevated thermal absorber. The mirrors move so as to focus solar radiation onto the absorber; the absorber contains a bank of high-pressure water pipes through which water is pumped and gradually boils. The process of ??direct steam generation?? in very long pipes, up to 300 m in a straight run, has not previously been performed at this scale; other systems use shorter pipe runs, or use other fluids such as non-boiling oil. This thesis addresses a broad range of design issues relating to the CLFR prototype and its components. Beam solar radiation at the prototype site is estimated from available data including satellite-derived and ground-based measurements. Existing correlations for the beam component of global radiation do not apply well to Australian conditions so a new correlation is proposed. Computational fluid dynamics simulations establish radiative heat-loss as the dominant mode for the thermal absorber. Results are gathered for a range of sizes and shapes, and heat-loss correlations are derived for use in subsequent simulation. Two-phase flow in the absorber direct-steam-generation process is examined, and a detailed model including, pipe-friction pressure drops, flow-boiling heat transfer and cavity heat loss is presented, with validation against the experimental results of other workers. A series of ??performance maps?? give the predicted outlet flow regime for varied inlet conditions, allowing selection of desired operating points. A full system model is given that integrates this absorber model with ancillary components including the pump and connecting pipework; the model is used to evaluate pumping requirements and to establish expected operating conditions. The inherent pressure instability arising from the two phase flow is examined and orifice plates are sizes to stabilise this effect. A dynamic model for the absorber pipe flow using fully implicit finite difference techniques and accurate IAPWS-IF97 steam properties gives the predicted behaviour during solar transients at both long and short time-scales.
| Identifer | oai:union.ndltd.org:ADTP/257730 |
| Date | January 2008 |
| Creators | Pye, John Downing, Mechanical & Manufacturing Engineering, Faculty of Engineering, UNSW |
| Publisher | Publisher:University of New South Wales. Mechanical & Manufacturing Engineering |
| Source Sets | Australiasian Digital Theses Program |
| Language | English |
| Detected Language | English |
| Rights | http://unsworks.unsw.edu.au/copyright, http://unsworks.unsw.edu.au/copyright |
Page generated in 0.0026 seconds