In Canadian remote northern communities most electricity is generated by burning diesel fuel. However, because it is expensive to import fuel into remote communities the cost of electricity is very high. Waste management is also difficult in remote northern communities. The goal of this thesis was to investigate the co-gasification of refuse waste materials and biomass as a means of reducing solid waste volumes while also using locally available materials for power generation.
As part of this research, thermo-gravimetric analysis (TGA) was investigated as a potential means of characterizing refuse derived fuels (RDF). Laboratory sample preparation of RDF for TGA had not been thoroughly considered. Laboratory sample preparation is important since RDF is very heterogeneous compared to other solid fuels and since TGA typically requires a very small sample size. A TGA method was applied to a variety of materials prepared from a commercially available RDF using a variety of procedures. The repeatability of the experimental results was related to the sample preparation methods. Cryogenic ball milling was found to be an appropriate means of preparing RDF samples for TGA. Applicability of the TGA method to the determination of the renewable content of RDF was considered.
Air-blown auto-thermal gasification experiments using materials representative of waste and biomass were performed at 725°C, 800°C, and 875°C, using a 0.15 m internal diameter bubbling fluidized bed gasifier located at NRCan CametENERGY in Ottawa, Ontario. Commercially prepared RDF and PET scrap were used to represent waste materials. Commercially produced hardwood pellets were used to represent biomass. The co-gasification of hardwood pellets and commercially produced RDF indicated that each fuel make a contribution to the results which is proportional to its fraction in the feed mixture. Inclusion of the RDF in the fuel mixture led to bed agglomeration at the 875°C temperature condition. Higher temperatures were found to provide better conversion of the fuel to gas, and the limitation which inclusion of RDF places on the operating temperature of the gasifier negatively affects conversion of biomass.
Results obtained with RDF suggested that utilization of mixed waste for a thermal conversion process located in a Canadian remote northern community is probably not a viable option. It was then decided to target plastic waste in particular. Plastic could be source-separated, collected, and gasified alongside biomass. Polyethylene terephthalate (PET), which is often used for food and beverage containers, was chosen to represent plastic. Initially, attempts were made to co-gasify mixtures of PET pellets and hardwood pellets. These attempts failed due to the formation of coke above the bed. To alleviate these problems hardwood-PET composite pellets were manufactured and these were gasified at 725°C, 800°C, and 875°C. Inclusion of PET in the pellets dramatically increased the amount of tar produced during gasification.
| Identifer | oai:union.ndltd.org:uottawa.ca/oai:ruor.uottawa.ca:10393/33157 |
| Date | January 2015 |
| Creators | Robinson, Travis |
| Contributors | Mehrani, Poupak |
| Publisher | Université d'Ottawa / University of Ottawa |
| Source Sets | Université d’Ottawa |
| Language | English |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0024 seconds