Return to search

Preparation of thin insulating films by plasma anodization

The plasma anodization of polycrystalline niobium samples has been undertaken using a d.c. glow discharge in oxygen. The apparatus used, which has facilities for in situ ellipsometry measurements and sample temperature control, is described.
Anodizations were carried out at various constant current densities up to 1.5 mA cm⁻² , and Langmuir probes were used to estimate the volt drop across the oxide during growth. The ellipsometry measurements yield oxide thickness and refractive
index, and indicate that the films have a two-layer structure. Ionic currents are calculated from growth rates using Faraday's Law. Ionic current and oxide field strength data are analyzed and compared with published solution anodization
results on the basis of the classical model of ionic conduction at high field strengths. The permittivity and loss factor of the oxide films are deduced from bridge measurements on capacitor structures produced by depositing counterelectrodes on the oxide surface. The introduction of water into the discharge
was investigated, and found to affect the oxide growth rate. / Applied Science, Faculty of / Electrical and Computer Engineering, Department of / Graduate

Identiferoai:union.ndltd.org:UBC/oai:circle.library.ubc.ca:2429/34510
Date January 1969
CreatorsOlive, Graham
PublisherUniversity of British Columbia
Source SetsUniversity of British Columbia
LanguageEnglish
Detected LanguageEnglish
TypeText, Thesis/Dissertation
RightsFor non-commercial purposes only, such as research, private study and education. Additional conditions apply, see Terms of Use https://open.library.ubc.ca/terms_of_use.

Page generated in 0.0017 seconds