<p>Ecohydrological models are extensively used to evaluate land
use, land management and climate change impacts on hydrology and in-stream
water quality conditions. The scale at which these models operate influences
the complexity of processes incorporated within the models. For instance, a
large scale hydrological model such as Soil and Water Assessment Tool (SWAT)
that runs on a daily scale may ignore the sub-daily scale in-stream processes.
The key processes affecting in-stream solute transport such as advection,
dispersion and transient storage (dead zone) exchange can have considerable
effect on the predicted stream solute concentrations, especially for localized
studies. To represent realistic field conditions, it is therefore required to
modify the in-stream water quality algorithms of SWAT by including these
additional processes. Existing reach-scale solute transport models like OTIS
(One-dimensional Transport with Inflow and Storage) considers these processes
but excludes the actual biochemical reactions occurring in the stream and
models nutrient uptake using an empirical first-order decay equation.
Alternatively, comprehensive stream water quality models like QUAL2E (The
Enhanced Stream Water Quality Model) incorporates actual biochemical reactions
but neglects the transient storage exchange component which is crucial is
predicting the peak and timing of solute concentrations. In this study, these
two popular models (OTIS and QUAL2E) are merged to integrate all essential
solute transport processes into a single in-stream water quality model known as
‘Enhanced OTIS model’. A generalized model with an improved graphical user
interface was developed on MATLAB platform that performed reasonably well for
both experimental data and previously published data (R<sup>2</sup>=0.76). To
incorporate this model into large-scale hydrological models, it was necessary
to find an alternative to estimate transient storage parameters, which are
otherwise derived through calibration using experimental tracer tests. Through
a meta-analysis approach, simple regression models were therefore developed for
dispersion coefficient (D), storage zone area (A<sub>s</sub>) and storage
exchange coefficient (α) by relating them to easily obtainable hydraulic
characteristics such as discharge, velocity, flow width and flow depth. For
experimental data from two study sites, breakthrough curves and storage
potential of conservative tracers were predicted with good accuracy (R<sup>2</sup>>0.5)
by using the new regression equations. These equations were hence recommended
as a tool for obtaining preliminary and approximate estimates of D, A<sub>s</sub>
and α when reach-specific calibration is unfeasible. </p>
<p> </p>
<p>The existing water quality module in SWAT was replaced with
the newly developed ‘Enhanced OTIS model’ along with the regression equations
for storage parameters. Water quality predictions using the modified SWAT model
(Mir-SWAT) for a study catchment in Germany showed that the improvements in process
representation yields better results for dissolved oxygen (DO), phosphate and
Chlorophyll-a. While the existing model simulated extreme low values of DO, Mir-SWAT
improved these values with a 0.11 increase in R<sup>2</sup> value between
modeled and measured values. No major improvement was observed for nitrate
loads but modeled phosphate peak loads were reduced to be much closer to
measured values with Mir-SWAT model. A qualitative analysis on Chl-<i>a</i> concentrations also indicated that
average and maximum monthly Chl-<i>a</i>
values were better predicted with Mir-SWAT when compared to SWAT model,
especially for winter months. The newly developed in-stream water quality model
is expected to act as a stand alone model or coupled with larger models to
improve the representation of solute transport processes and nutrient uptake in
these models. The improvements made to SWAT model will increase the model
confidence and widen its extent of applicability to short-term and localized
studies that require understanding of fine-scale solute transport dynamics. </p>
| Identifer | oai:union.ndltd.org:purdue.edu/oai:figshare.com:article/8133323 |
| Date | 02 August 2019 |
| Creators | Femeena Pandara Valappil (6703574) |
| Source Sets | Purdue University |
| Detected Language | English |
| Type | Text, Thesis |
| Rights | CC BY 4.0 |
| Relation | https://figshare.com/articles/IMPROVING_NUTRIENT_TRANSPORT_SIMULATION_IN_SWAT_BY_DEVELOPING_A_REACH-SCALE_WATER_QUALITY_MODEL/8133323 |
Page generated in 0.0031 seconds