This master's thesis focuses on the use of the Renishaw's Equator gauging system in cooperation with the industrial robot. The target is to design the robotized workcell which contains these two products. Robot acts as a manipulator for inserting and sorting out the workpieces into the "good" and "bad" pallets according to measured results from the Equator. Equator uses a parallel kinematics and probing system which is normally used on coordinate measuring machines. Therefore there is the introduction to the parallel and serial kinematic structures, to the problems of the coordinate measuring machines in the first part of this thesis. It was made a separation of the probing systems into a few basic categories, description of the typical representatives of these categories and of the other important accessories of the coordinate measuring machines, too. The second part of the thesis contains a description of the Equator gauging system, the industrial robot which I used and their accessories. In this part is mentioned a few examples of measurement automation in industry practice, too. The third part devotes to the design of the robotized workcell and contains all the important requirements for the realization.
| Identifer | oai:union.ndltd.org:nusl.cz/oai:invenio.nusl.cz:230961 |
| Date | January 2013 |
| Creators | Tvardek, Michal |
| Contributors | Sláma, Josef, Knoflíček, Radek |
| Publisher | Vysoké učení technické v Brně. Fakulta strojního inženýrství |
| Source Sets | Czech ETDs |
| Language | Czech |
| Detected Language | English |
| Type | info:eu-repo/semantics/masterThesis |
| Rights | info:eu-repo/semantics/restrictedAccess |
Page generated in 0.0017 seconds