Return to search

Experimental and Modeling Studies of the Methane Steam Reforming Reaction at High Pressure in a Ceramic Membrane Reactor

This dissertation describes the preparation of a novel inorganic membrane for hydrogen permeation and its application in a membrane reactor for the study of the methane steam reforming reaction. The investigations include both experimental studies of the membrane permeation mechanism and theoretical modeling of mass transfer through the membrane and simulation of the membrane reactor with 1-D and 2-D models.

A hydrothermally stable and hydrogen selective membrane composed of silica and alumina was successfully prepared on a macroporous alumina support by chemical vapor deposition in an inert atmosphere at high temperature. Before the deposition of the silica-alumina composite, multiple graded layers of alumina were coated on the alumina support with a mean pore size of 100 nm by the sequential application of three boehmite sols with gradually decreasing sol particle sizes of 630, 200 and 40 nm, respectively. The resulting supported composite alumina-silica membrane had high permeability for hydrogen in the order of 10-7 mol m-2 s-1 Pa-1 at 873 K with a H2 /CH4 selectivity of 940 and exhibited much higher stability to water vapor at the high temperature of 873 K. In addition, the same unusual permeance order of Heï¼ H2ï¼ Ne previously observed for the pure silica membrane was also observed for the alumina-silica membrane, indicating that the silica structure did not change much after introduction of the alumina. The permeation of hydrogen and helium through vitreous glass and silica membranes was modeled using ab initio density functional calculations. Comparison of the calculated activation energies to those reported for vitreous glass (20—40 kJ mol -1) indicated the presence of 5- and 6-membered siloxane rings, consistent with the accepted structure of glass as a disordered form of cristobalite.

The experimental studies of the steam reforming of methane were examined at various temperatures (773-923 K) and pressures (1-20 atm) with a commercial Ni/MgAl2O4 catalyst in a hydrogen selective silica-alumina membrane reactor and compared with a packed bed reactor. One-dimensional and two-dimensional modeling of the membrane rector and the packed bed reactor were performed at the same conditions and their performances were compared with the values obtained in the experimental study. Improved methane conversions and hydrogen yields were obtained in the membrane reactor compared to the packed bed reactor at all temperatures and pressures. From the two modeling studies, it was also found out that the two-dimensional model performed better in the membrane reactor case especially at higher pressures. / Ph. D.

Identiferoai:union.ndltd.org:VTETD/oai:vtechworks.lib.vt.edu:10919/29580
Date10 December 2007
CreatorsHacarlioglu, Pelin
ContributorsChemical Engineering, Oyama, Shigeo Ted, Gibbs, Gerald V., Marand, Eva, Cox, David F.
PublisherVirginia Tech
Source SetsVirginia Tech Theses and Dissertation
Detected LanguageEnglish
TypeDissertation
Formatapplication/pdf, application/pdf, application/pdf, application/pdf, application/pdf, application/pdf, application/pdf, application/pdf
RightsIn Copyright, http://rightsstatements.org/vocab/InC/1.0/
Relationchp1rev1.pdf, chp6rev1.pdf, chp4rev1.pdf, chp3rev1.pdf, chp2rev1.pdf, chp5rev1.pdf, Vitarev1.pdf, chp7rev1.pdf

Page generated in 0.0025 seconds