The research presented in this thesis regards walking of quadruped robots, and particularly the walking of the Warp1 robot. The motivation for the robot is to provide a platform for autonomous walking in rough terrain. The thesis contains six papers ranging from development tools to actuation of robot legs. The first paper describes the methods and tools made for control development. These tools feature: programming of the robot without low level coding (C-code); that the controller has to be built only once for simulation and experiments; and that names of variables and constants are unchanged through the chain of software Maple -- Matlab -- Simulink -- Real~Time~Workshop -- xPC--Target. Three controllers, each making the robot walk are presented. The first controller makes the robot walk using the crawl gait. The method uses static stability as method for keeping balance and the instantaneous trunk motions are given by a concept using the so called weight ratios. A method for planning new footholds based on the positions of the existing footholds is also proposed and the controller experimentally verified. The second walking controller shows that the robot also can walk dynamically using the trot gait. The method proposed uses information from ground contact sensors on the feet as input to control balance, instead of, which is common, inertial sensors. It is experimentally verified that Warp1 can trot from level ground onto a slope and turn around while staying balanced. The main ideas of these two walking controllers are fused in the third which enables smooth transitions between crawl and trot. The idea of using the ground contact sensors from the first controller is here used to estimate the position of the center of mass. This controller uses weight ratios in the gait crawl as well as in the dynamic gait trot. Hence, the method of using weight ratios is not only useful for static stability for which it was originally intended. The controller is experimentally verified on Warp1. The Warp1 robot weighs about 60 kg, has 0.6 m long legs with three actuated joints on each. The speed and strength is sufficient only for slow walking, even though the installed power indicates that it should be enough for faster walking. The reason is that a walking robot often needs to be strong but slow when the feet are on the ground and the opposite when in the air. This can not be achieved with the motors and transmissions currently used. A transmission called the passively variable transmission (PVT) is proposed which enhance motor capabilities of robot joints. It is elastic, nonlinear and conservative. Some general properties for elastic transmissions are derived such that they can be compared with conventional transmissions. The PVT gives strong actuation at large loads and fast actuation at small loads. The proposed transmission is compared to a conventional transmission for a specific task, and the result is that a smaller motor can be used. / QC 20100831
| Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:kth-600 |
| Date | January 2006 |
| Creators | Ingvast, Johan |
| Publisher | KTH, Maskinkonstruktion (Avd.), Stockholm : KTH |
| Source Sets | DiVA Archive at Upsalla University |
| Language | English |
| Detected Language | English |
| Type | Doctoral thesis, comprehensive summary, info:eu-repo/semantics/doctoralThesis, text |
| Format | application/pdf |
| Rights | info:eu-repo/semantics/openAccess |
| Relation | Trita-MMK, 1400-1179 ; 2006-02 |
Page generated in 0.0029 seconds