Abstract
Despite the large amount of research work in condition based maintenance and condition monitoring methods, there is still a need for more reliable and accurate methods.
The clear evidence of that need is the continued dependence on time based maintenance, especially for critical applications such as turbomachinery and airplane engines. The lack of accurate condition monitoring systems could lead to not only the unexpected failures as well as the resulting hazards and repair costs, but also a huge waste of material and time because of unnecessary replacement due to false alarms and unnecessary repair and maintenance.
Temperature change is a phenomenon that accompanies every dynamic activity in the universe. However, it has not been adequately exploited for mechanical system condition monitoring. The reason is the slow response of current temperature monitoring systems compared to other condition monitoring methods such as vibration analysis. Many references inferred that the change in temperature is not sensible until approaching the end of the monitored component life and even the whole system life (Kurfess, et al., 2006; Randall, 2011; Patrick, et al., March 7-14, 2009).
On the other hand, the most commonly used condition monitoring method, i.e., vibration analysis, is not free from pitfalls. Although vibration analysis has shown success in detecting some bearing faults, for other faults like lubrication problems and gradual wear it is much less effective. Also, it does not give a reliable indication of fault severity for many types of bearing faults.
The advancement of thermography as a temperature monitoring tool encourages the reconsideration of temperature monitoring for mechanical system fault detection. In addition to the improved accuracy and responsiveness, it has the advantage of non-contact monitoring which eliminates the need for complex sensor mounting and wiring especially for rotating components.
Therefore, in current studies the thermography-based monitoring method is often used either as a distinct method or as a complementary tool to vibration analysis in an integrated condition monitoring system. The main objectives of this study are hence to:
1. Define heat sources in the rolling element bearings and overview two of the most famous bearing temperature calculation methods.
2. Setup a bearing test rig that is equipped with both vibration and temperature monitoring systems.
3. Develop a temperature calculation analytical model for rolling element bearing that include both friction calculation and heat transfer models. The friction calculated by the model will be compared to that calculated using the pre-defined empirical methods. The heat transfer model is used for bearing temperature calculation that will be compared to the experimental measurement using different temperature monitoring devices.
4. Propose a new in-band signal enhancement technique, based on the synchronous averaging technique, Autonomous Time Synchronous Averaging (ATSA) that does not need an angular position measuring device. The proposed method, in addition to the Spectral Kurtosis based band selection, will be used to enhance the bearing envelope analysis.
5. Propose a new method for classification of the bearing faults based on the fault severity and the strength of impulsiveness in vibration signals. It will be used for planning different types of tests using both temperature and vibration methods.
6. Develop and experimentally test a new technique to stimulate the bearing temperature transient condition. The technique is supported by the results of finite element modeling and is used for bearing temperature condition monitoring when the bearing is already running at thermal equilibrium condition.
Identifer | oai:union.ndltd.org:uottawa.ca/oai:ruor.uottawa.ca:10393/31379 |
Date | January 2014 |
Creators | Moussa, Wael |
Contributors | Liang, Ming |
Publisher | Université d'Ottawa / University of Ottawa |
Source Sets | Université d’Ottawa |
Language | English |
Detected Language | English |
Type | Thesis |
Page generated in 0.0184 seconds