De-inking sludge generated from pulp and paper industry is considered hazardous since it may contain heavy metals such as Cd, Cr, and Pb. Hence, the de-inking sludge needs to be treated before being disposed of. Sludge combustion is a proven disposal technology, which generates fly ash containing a portion of the heavy metals that may leach out under uncontrolled conditions. The aim of this thesis is to implement a new multi-zone temperature combustion technique (Low-High-Low temperature combustion, LHL) to help contain and immobilize the heavy metals within fly ash particles. During the LHL, the waste will be initially fed into a low-temperature zone (<1100 K) and then subjected to the high-temperature treatment (~1480 K) that will be followed by another low-temperature zone (~1100 K). / This dissertation describes the detailed design and construction of a novel pilot-scale combustion facility, called the Multi-Mode Combustion Facility (MCF), used as a multidisciplinary research tool for investigating the thermal remediation of contaminated solid residues. The MCF is capable of operating in two different modes: Fluidized-Bed combustion mode (FBC) and Single burner furnace mode (SBF). However, this project focuses on the FBC mode (minimum fluidization velocity of 0.42 m/s and bed temperature of 1073 K). / This research compares the combustion characteristics of de-inking sludge obtained in the LHL and in the conventional combustion techniques. The following properties of particulates were studied: morphological evolution of solid particles, structural porosity, metals interactions with fly ash particles, and leachability. / The LHL's final supermicron spherical fly ash went through a molten phase with submicron particles attached to the fly ash particles surfaces. Thus, reducing its porosity to 19%. However, the amorphous final fly ash obtained in the conventional technique reveals 32% porosity. It was found that the physical characteristics of the final LHL's fly ash are the main cause for the reduced heavy metals leachability rates of 0.18, 0.046, and 0.92% for Cd, Cr, and Pb, respectively. The conventional technique had 53.28, 16.79, and 5.20% of Cd, Cr, and Pb respectively, leaching out due to the high porosity percentages. In conclusion, the LHL technique allows for controlling the heavy metals emission from FBCs, while using a waste to energy approach and maintaining environmentally acceptable gas emission levels.
Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:QMM.84238 |
Date | January 2003 |
Creators | El-dabbagh, Fadi |
Contributors | Kozinski, Janusz (advisor) |
Publisher | McGill University |
Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
Language | English |
Detected Language | English |
Type | Electronic Thesis or Dissertation |
Format | application/pdf |
Coverage | Doctor of Philosophy (Department of Mining, Metals and Materials Engineering.) |
Rights | All items in eScholarship@McGill are protected by copyright with all rights reserved unless otherwise indicated. |
Relation | alephsysno: 002083141, proquestno: AAINQ98244, Theses scanned by UMI/ProQuest. |
Page generated in 0.0116 seconds