Return to search

Comparison of an anaerobic baffled reactor and a completely mixed reactor : start-up and organic loading tests.

The aim of the investigation was to compare the performance of an anaerobic baffled reactor (ABR)

with a completely mixed anaerobic reactor (CMAR). The ABR was operated with a hydraulic retention

time (HRT) of 20 h while the CMAR was operated at 20 d. A control experiment was conducted with a

CMAR operated at a constant hydraulic retention time and substrate feed concentration. During the

first phase, the start-up performance of the ABR and CMAR were compared. In the second phase of the

study the steady state COD removals were compared.

The laboratory completely mixed anaerobic reactor was a 20L glass vessel with a stirrer coming in

through the neck. A second type of reactor, anaerobic baffled reactor (ABR) was also operated. The

ABR was a rectangular perspex box with internal vertical baffles alternately hanging and standing. The

baffles divide the reactor into eight compartments with a total working volume of 7.5 L. Each baffle is

angled at about 45Q to distribute the flow towards the centre of the upcomer. The reactors were seeded

with raw sewage and allowed to stand for 3 days after which a continous feed of sucrose and basal salts

was commenced. The initial HRT for the ABR and the CMAR were 60 h and 30 days respectively.

When the reactors reached steady state (pH, gas production, gas composition and alkalinity), the HRT

was reduced in a stepwise fashion (ABR 60 h to 35 h to 20 h and CMAR 35 d to 30 d to 20 d). At the

final HRT the COD removals were similar (67 %). The ABR took 120 d to attain final steady state

while the CMAR took 200 d.

The organic loading tests were undertaken with a stepwise increase (doubling) in the influent substrate

concentration. The feeding commenced at an organic loading rate (OLR) of 4.8 kg/m(3).d for the ABR.

The flow rate (HRT) into both reactors and other parameters were kept constant (HRT of 20 h and 20 d

for ABR and CMAR respectively). The substrate concentration was increased from 4 gCOD/L (4.8

kg/m(3).d) to 64 gCOD/L (76.8 kg/m(3).d) for the ABR. For the CMAR it was increased from 4 gCOD/L

(0.25 kg/m(3).d) to 32 gCOD/L (2 kg/m(3).d). The method used was to increase the organic loading rate

until the reactors failed. Since the two reactors had different operating HRTs, the tests began when both

had the same COD removal rate of about 60 % COD reduction. The same parameters as in the start-up

period were monitored for both reactors. The CMAR had a COD removal efficiency ca. 70 %, which

did not fluctuate when OLR was increased. The ABR reached a maximum COD removal of 80 %. An

increase in the OLR led to an initial decrease in the COD removal until the biomass recovered and the

high COD (80 %) removal rates resumed. The ABR reached a maximum OLR of 76.8 kg/m(3).d whilst

the CMAR reached a maximum OLR of 2.0 kg/m(3).d. The investigations showed that the ABR could be

operated at higher organic loads than the CMAR and give the same organic removal rate. This verified

the importance of increasing the SRT/HRT ratio in anaerobic reactors. The CMAR, however, proved to

be stable to changes in the influent feed strength, as there was no immediate noticeable changes in the

gas production. / Thesis (M.Sc.Eng.)-University of Natal, Durban, 2000.

Identiferoai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:ukzn/oai:http://researchspace.ukzn.ac.za:10413/5584
Date January 2000
CreatorsMudunge, Reginald.
ContributorsBuckley, Christopher A.
Source SetsSouth African National ETD Portal
LanguageEnglish
Detected LanguageEnglish
TypeThesis

Page generated in 0.0021 seconds