The "Water-Blow" Pulsation generator has been used to produce pulsing fluid flow in an off-the-shelf industrial single pass heat exchanger containing 5/8 in. 0. D. tubes, 37 inches long. Experimental results showed that heat transfer from steam to flowing water could be enhanced by as much as 100%, although a more practical enhancement would likely be about 40%. From the experimental results it was estimated that pulsing air requirement (standard cu. ft. air per cu. ft. water) increased linearly from about 0 to 4.0 over a range of heat transfer enhancement from 0 to 40%. Two factors which influenced pulsing air requirement were the air surge volume sizes and the pressure fluctuations which occurred therein. / Thesis / Master of Engineering (ME)
Identifer | oai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/24530 |
Date | 01 1900 |
Creators | Keil, Randall |
Contributors | Baird, M. H. I., Chemical Engineering |
Source Sets | McMaster University |
Language | English |
Detected Language | English |
Type | Thesis |
Page generated in 0.0888 seconds