Return to search

Mechanism studies for crossflow microfiltration with pulsatile flow

The mechanism of how pulsatile flow affects flux behaviour in crossflow micro-filtration was investigated. The effects of pulsatile flow were sub-divided into shear effects and backflushing effects. A servo-valve hydraulic piston pump was applied to generate pulsatile flows in the membrane module with particular waveforms. Four types of fluid pulsation with specific flow-rate and pressure waveforms were produced for experimental tests. Two parameters, /dVcf\dt/ maxand Pmin, were examined independently for their effect during pulsatile flow, which was estimated by comparing the cake resistance during steady flow and pulsatile flow at the same mean crossflow velocity, trans-membrane pressure and membrane resistance. Filtration tests for all the pulsatile flows with clean water confirmed that pulsatility only affects cake depositions. Without particles, no flux improvement was obtained. The results for the microfiltration of 0.5g/1 silica suspension showed that for pulsatile flows without backflushing (i.e. no negative transmembrane pressure peak), the fluid pulsation decreased cake resistance when the shear related parameter /dVcf\dt/max exceeded a critical value for each given waveform. When the instantaneous transmembrane pressure reached negative values, i.e. back-flushing occurred, the cake resistance was reduced for all pressure waves tested. Cake resistance was reduced more for more negative P min. With two of the waveforms tested, the cake resistance was almost completely eliminated. In contrast, the shear affected cake resistance reduction differently for each waveform. Comparing cake reduction results for different pulsatile waveforms, it was found that, for the square wave, the cake resistance reduction was higher for both shear and backflushing effect tests, while for the short spike waveform, the cake resistance reduction was lower. The flux waveforms were seen to follow the variations in transmembrane pressure. The flux response time was longer than the time required for the pressure changes, but was not dependent on the direction of the pressure change.

Identiferoai:union.ndltd.org:ADTP/242084
Date January 1995
CreatorsLi, Hong-yu, Graduate School of Biomedical Engineering, Faculty of Engineering, UNSW
PublisherAwarded by:University of New South Wales. Graduate School of Biomedical Engineering
Source SetsAustraliasian Digital Theses Program
LanguageEnglish
Detected LanguageEnglish
RightsCopyright Hong-yu Li, http://unsworks.unsw.edu.au/copyright

Page generated in 0.0021 seconds