Return to search

Factors influencing cartilage wear in an accelerated in vitro test: collagen fiber orientation, anatomic location, cartilage composition, and photo-chemical crosslinking

Indiana University-Purdue University Indianapolis (IUPUI) / Articular cartilage (AC) is a strong but flexible connective tissue that covers and
protects the end of the long bones. Although cartilage has excellent friction and wear
properties that allow smooth joint function during daily activities, these properties
are not fully understood. Many material properties of cartilage are anisotropic and
vary with anatomic location and the composition of the tissue, but whether this is
also true for cartilage friction and wear has not been previously determined. Furthermore, cartilage disease and injury are major health concerns that affect millions of
people, but there are few available treatments to prevent the progression of cartilage
degeneration. Collagen crosslinking may be a potential treatment to reduce cartilage
wear and slow or prevent the progression of cartilage disease. The objectives of this
thesis were to investigate the relationships between the friction/wear characteristics of
cartilage and the orientation of the preferred fiber direction, the anatomic location of
the tissue, the composition of the tissue, and exogenous photochemical crosslinking.

In the superficial zone, AC has preferential fiber direction which leads to anisotropic
material behavior. Therefore, we hypothesized that AC will show anisotropic behavior between longitudinal and transverse direction in an accelerated, in vitro wear test
on bovine cartilage in terms of friction and wear. This hypothesis was proven by the
quantification of glycosaminoglycans released from the tissue during the wear test,
which showed that more glycosaminoglycans were released when the wear direction
was transverse to the direction of the fibers. However, the hydroxyproline released
from the tissue during the wear test was not significantly different between the two
directions, nor was the coefficient of friction.

The material properties of AC can also vary with anatomic location, perhaps due
to differences in how the tissue is loaded in vivo. We hypothesized that cartilage
from a higher load bearing site will give better wear resistance than cartilage from
lower load bearing regions. However, no differences in friction or wear were observed
between the different anatomic locations on the bovine femoral condyles. The concentration of collagen, glycosaminoglycans, cells and water in the tissue was also
quantified, but no significant differences in tissue composition were found among the
locations that were tested.

Although wear did not vary with anatomic location, variation in the wear measurements were relatively high. One potential source of variation is the composition
of the cartilage. To determine whether cartilage composition influences friction and
wear, a correlation analysis was conducted. An accelerated, in vitro wear test was
conducted on cartilage from bovine femoral condyles, and the tissue adjacent to the
wear test specimens was analyzed for collagen, glycosaminoglycan, cell, and water
content. Because wear occurs on the cartilage surface, the superficial zone of the
cartilage might play an important role in wear test. Therefore, composition of the
adjacent cartilage was determined in both the superficial zone and the full thickness
of the tissue. A significant negative correlation was found between wear and collagen
content in the full thickness of the tissue, and between the initial coefficient of friction
and the collagen content in the superficial zone. This correlation suggests that variation in the collagen content in the full thickness of the cartilage partially explains
differences in amount of wear between specimens.

The wear resistance of cartilage can be improved with exogenous crosslinking
agents, but the use of photochemical crosslinking to improve wear resistance is not well
understood. Two photochemical crosslinking protocols were analyzed to improve the
wear resistance of the cartilage by using chloro-aluminum phthalocyanine tetrasulfonic
acid (CASPc) and 670nm laser light. The cartilage treated with the two crosslinking
protocols had lower wear than the non-treated group without changing the friction
properties of the cartilage.

Identiferoai:union.ndltd.org:IUPUI/oai:scholarworks.iupui.edu:1805/17000
Date January 2018
CreatorsHossain, M. Jayed
ContributorsWagner, Diane, Jones, Alan, Holguin, Nilsson
Source SetsIndiana University-Purdue University Indianapolis
LanguageEnglish
Detected LanguageEnglish
TypeThesis

Page generated in 0.0028 seconds