Two experiments were performed to investigate the interaction of a combustion wave with
porous media. The first experiment was performed in a 1.22m long, 76mm wide, and
152mm high horizontal channel with a nitrogen-diluted stoichiometric methane-oxygen
mixture at initial pressures of 20-50kPa. A layer of 12.7mm diameter ceramic-oxide spheres
was placed along the bottom to partially obstruct the channel, leaving a gap of free space
above. For a fixed gap height the bead layer thickness had very little effect on explosion
propagation. For a fixed bead layer thickness the explosion propagation was strongly
influenced by the gap height. For example, a 31% nitrogen diluted mixture at room
temperature resulted in DDT for a gap height of 38mm at initial pressures of 30-50 kPa, but
not for 109mm over the same pressures. The gap above the bead layer permits DDT as long
as the gap height is larger than one detonation cell width. Propagation of the detonation
wave over the bead layer is possible if the gap height can accommodate at least two
detonation cells. For a 38mm gap, velocity measurements and sooted foil imprints indicate
that the detonation undergoes successive failure and re-initiation, referred to as “galloping”
in the literature.
In the second experiment, the head-on collision of a combustion front with a layer of
3 and 12.7mm diameter ceramic-oxide spheres was investigated in a 61cm long, 76.2mm
diameter vertical tube for a nitrogen-diluted stoichiometric ethylene-oxygen mixture at initial
pressures of 10-100kPa. Four orifice plates were placed at the ignition end to accelerate the
premixed flame to a “fast-flame” or a detonation wave. For fast-flames pressures recorded at
the bead layer face were up to five times the reflected CJ detonation pressure. This explosion
iv
developed by two distinct mechanisms: a) shock reflection off the bead layer face and b)
shock transmission into the bead layer and subsequent explosion therein. The measured
explosion delay time (time after shock reflection from the bead layer face) was found to be
independent of the incident shock velocity. Thus, it was shown that explosion initiation is
not the direct result of shock reflection but is more likely due to the interaction of the reflected shock with the trailing flame. The bead layer was found to be very effective in attenuating the explosion and isolating the tube endplate. / Thesis (Master, Mechanical and Materials Engineering) -- Queen's University, 2008-08-15 17:57:22.213
| Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:OKQ.1974/1362 |
| Date | 21 August 2008 |
| Creators | Hlouschko, Stefan Joseph |
| Contributors | Queen's University (Kingston, Ont.). Theses (Queen's University (Kingston, Ont.)) |
| Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
| Language | English, English |
| Detected Language | English |
| Type | Thesis |
| Format | 3031784 bytes, application/pdf |
| Rights | This publication is made available by the authority of the copyright owner solely for the purpose of private study and research and may not be copied or reproduced except as permitted by the copyright laws without written authority from the copyright owner. |
| Relation | Canadian theses |
Page generated in 0.0025 seconds