Increasing concerns on environment and greenhouse effect, coupled with increased construction prices led to the development of new technologies by the Asphalt industry to produce Asphalt Concrete (AC) pavements. Extensive research is being done to evaluate the impact and performance of these new technologies. Warm Mix Asphalt (WMA) is one of these technologies that allow mixing, production, placing and compaction of asphalt mixes at significantly lower temperatures as compared to the traditional Hot Mix Asphalt (HMA) practice. Lower temperatures result in reduced fuel usage, fume exhausts, greenhouse gas emissions, wear and tear at plants; while enhancing worker health and safety conditions. The performance characteristics of asphalt mixtures containing WMA technologies may be affected and should be quantified.
A detailed laboratory study has been conducted to evaluate and quantify the performance of different WMA technologies. Eleven mixes from three overlay field projects across Louisiana were taken into consideration. Evotherm, Rediset, Foaming and Latex were different warm mix technologies used. Each project included a companion HMA mixture section to allow comparison of WMA to conventional HMA. Mechanistic tests were conducted on plant producedlab compacted (PL) specimens to evaluate Rutting (permanent deformation), Fatigue/Fracture and Low temperature cracking performance of the mixtures at high, intermediate and low temperatures respectively. The testing factorial included Dynamic Modulus, Indirect Tensile Strength (ITS), Flow Number (FN), Loaded Wheel Tester (LWT), Beam Fatigue, Semi-Circular Bend (SCB), Dissipated Creep Strain Energy (DCSE), Thermal Stress Restrained Specimen Test (TSRST) and Modified Lottman Test. A Life Cycle Assessment (LCA) has been performed to evaluate the economic and environmental benefits of WMA.
Overall, the WMA mixtures showed similar performance compared to that of control HMA mixtures. Asphalt mixtures with Rediset and Latex showed better performance than conventional mixtures with respect to fatigue and permanent deformation. The use of WMA technologies resulted in lesser aging of the binder. Energy assessment has shown a 12-15 % energy savings. On average, $1.61 of cost savings per ton of produced asphalt was observed along with a considerable reduction in air pollutants without any reduction in the mechanistic performance of these mixtures.
| Identifer | oai:union.ndltd.org:LSU/oai:etd.lsu.edu:etd-11162012-082742 |
| Date | 27 November 2012 |
| Creators | VALLABHU, BHANU VIJAY |
| Contributors | Hassan, Marwa, Elseifi, Mostafa, Mohammad, Louay |
| Publisher | LSU |
| Source Sets | Louisiana State University |
| Language | English |
| Detected Language | English |
| Type | text |
| Format | application/pdf |
| Source | http://etd.lsu.edu/docs/available/etd-11162012-082742/ |
| Rights | unrestricted, I hereby certify that, if appropriate, I have obtained and attached herein a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to LSU or its agents the non-exclusive license to archive and make accessible, under the conditions specified below and in appropriate University policies, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report. |
Page generated in 0.0015 seconds