Return to search

A Control Algorithm To Minimize Torque Ripple And Acoustic Noise Of Switched Reluctance Motors

Despite its simple construction, robustness and low manufacturing cost, the application areas of SR motors are remained limited due to the high level of acoustic noise and torque ripple. In this thesis work, two different type of controllers are designed and implemented in order to minimize the acoustic noise and torque ripple which are considered as the major problems of SR motors. In this scope, first the possible acoustic noise sources are investigated. A sliding mode controller is designed and implemented to reduce the shaft torque ripple which is considered as a major source of acoustic noise. The performance of the controller is experimentally tested and it is observed that especially in low speed region reduction of torque ripple is significant. The torque ripple minimization performance of the controller is also tested at different speeds and the acoustic noise levels are recorded simultaneously. Comparing the noise mitigation with the noise reduction the correlation between the acoustic noise and shaft torque ripple is investigated. The results obtained from this investigation indicated that the torque ripple is not a major source of acoustic noise in SR motors. After this finding, radial force which is the other possible acoustic noise source of SRM is taken into consideration. The effects of control parameters on radial force and the motor efficiency are investigated via simulations. With the intuition obtained from this analysis, a switching angle neuro-controller is designed to minimize the peak level of radial forces. The performance of the mentioned controller is verified through noise records under steady state conditions. Regarding to the radial force simulations and the acoustic noise measurements, it is deduced that the radial force is the major source of acoustic noise. On the other hand, another controller is designed and implemented which increases the average torque per ampere value in order to increase the efficiency of the motor. It is seen that this controller has a good effect on increasing the efficiency but does not guarantee to operate at maximum efficiency.

Identiferoai:union.ndltd.org:METU/oai:etd.lib.metu.edu.tr:http://etd.lib.metu.edu.tr/upload/2/12609866/index.pdf
Date01 June 2008
CreatorsBizkevelci, Erdal
ContributorsErtan, Bulent Hulusi
PublisherMETU
Source SetsMiddle East Technical Univ.
LanguageEnglish
Detected LanguageEnglish
TypePh.D. Thesis
Formattext/pdf
RightsTo liberate the content for METU campus

Page generated in 0.0018 seconds