Return to search

Analysis of Taxi Test Data for an Unmanned Aerial VehicleImplemented with Fluidic Flow Control

Serpentine inlet ducts are utilized in many aircraft where the inlet capture area is located off the thrust line or there is a desire to conceal the engine compressor face. Due to the curvature that characterizes a compact serpentine duct, issues with flow distortion and total pressure loss at the engine face arise leading to reduction in propulsion system performance. Computational analysis has shown that flow control implementing micro-fluidic vortex generators significantly reduces the losses. Previous work at North Carolina State University has demonstrated the benefits of a fluidic flow control of this type in a highly compact serpentine inlet duct through the design and experimental static testing of a propulsion system for an uninhabited aerial vehicle. With the implementation of flow control, engine face distortion was reduced and propulsion system performance was increased. This work continues the investigation of the effectiveness of the fluidic flow control by examining the performance of the system during dynamic situations through high speed taxi testing of an uninhabited aerial vehicle implemented with this technology. Additionally, the collected data was used to compare calculated takeoff parameters to values calculated using standard takeoff analysis.

Identiferoai:union.ndltd.org:NCSU/oai:NCSU:etd-07062006-122530
Date07 July 2006
CreatorsTurner, Drew Patrick
ContributorsDr. Sharon Lubkin, Dr. Ashok Gopalarathnam, Dr. Charles E. Hall, Jr.
PublisherNCSU
Source SetsNorth Carolina State University
LanguageEnglish
Detected LanguageEnglish
Typetext
Formatapplication/pdf
Sourcehttp://www.lib.ncsu.edu/theses/available/etd-07062006-122530/
Rightsunrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to NC State University or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report.

Page generated in 0.008 seconds