<p>Experiments have been conducted using vane-type vortex generators to control flow separation and exit flow distortion in a diffusing duct. The primary purpose is to examine the feasibility of using surface-mounted hot-film sensors to determine the extent of exit flow distortion. The experimental set-up consists of a two-dimensional blow down type wind tunnel with a variable diffuser exit. One diffuser wall is curved to produce a Stratford-like pressure gradient. The wall's placement is adjustable such that the adverse pressure gradient can be adjusted to promote separation. An active vortex generator array that can be placed at three streamwise locations is used to reduce the extent of flow separation and exit distortion.Diffuser surface pressure and exit total pressure measurements are obtained and compared to the hot-film data. The time-averaged mean and rms voltages from the hot-film data are used as indicators of flow separation and exit flow distortion.Results show that, with the use of the vortex generators, high mean voltages and low levels of rms voltage correlate well with improved pressure recovery. Conversely, poorer pressure recovery is associated with lower mean voltages and higher rms values compared to the baseline cases. Increased total pressures at the diffuser exit are accompanied by increases in hot-film mean voltages. These indicate higher shear stresses, which also correspond to increased flow uniformity. Lower variations in the rms voltages compared to the baseline cases also correlated well with improved total pressures at the diffuser exit.<P>
| Identifer | oai:union.ndltd.org:NCSU/oai:NCSU:etd-20010528-224402 |
| Date | 29 May 2001 |
| Creators | Jones, Warren Anthony |
| Contributors | Dr. Ndaona Chokani, Dr. Ashok Gopalarathnam, Committee Member, Dr. James Selgrade, Minor Representative |
| Publisher | NCSU |
| Source Sets | North Carolina State University |
| Language | English |
| Detected Language | English |
| Type | text |
| Format | application/pdf |
| Source | http://www.lib.ncsu.edu/theses/available/etd-20010528-224402 |
| Rights | unrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to NC State University or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report. |
Page generated in 0.0019 seconds