This study combined photocatalytic technology with activated carbon adsorption to decompose gaseous pollutants. Gaseous pollutants were initially adsorbed and concentrated by activated carbon and could be further decomposed more effectively by photocatalytic technology.
This study coated TiO2 on the activated carbon fiber (ACF) by a sol-gel process for conducting the adsorption and decomposition of acetone in a batch reactor. Operating parameters investigated in this study included the initial concentration of acetone (13.6 £gM and 27.2 £gM), reaction temperature (50¢J~70¢J), oxygen concentration (0.5%~20%), and water vapor (0 £gM~244.9 £gM). The incident UV light of 365 nm was irradiated by a 15-watt low-pressure mercury lamp placing above the photocatalytic batch reactor. The ACF coated with TiO2 was placed in the center of the reactor. Acetone was injected into the reactor to conduct photocatalytic tests. Reactants and products were analyzed quantitatively by a gas chromatography with electron capture detector (GC/ECD) and a flame ionization detector followed by a methaneizer (GC/FID-Methaneizer).
Results from the photocatalysis tests indicated that, among the commercial TiO2 (Degussa P-25), NO3-/TiO2 and SO42-/TiO2, SO42-/TiO2 had the best photoactivity reduced acetone concentration and reaction time substantially. The end products was mainly CO2 and CO, which resulted in the mineralization ratio above 95%. Results from the operating parameter tests revealed that the increase of the initial acetone concentration enhanced the amount of acetone adsorbed on the ACF, which however did not increase the reaction rate of acetone. Although the increase of reaction temperature could reduce the amount of acetone adsorbed on the ACF, decomposition rate of acetone could be promoted, so as the yield rate and mineralization ratio of products (CO2 and CO). Increasing oxygen concentration did not influence the decomposition significantly except for oxygen concentration lower than 1%. The increase of water vapor would slightly decrease the amount of acetone adsorbed on the ACF, which did not decrease the decomposition of acetone anyway. This study revealed that the decomposition of acetone on TiO2/ACF can enhance the mass transfer of acetone substantially.
| Identifer | oai:union.ndltd.org:NSYSU/oai:NSYSU:etd-0906105-173043 |
| Date | 06 September 2005 |
| Creators | Wu, Yu-jiuan |
| Contributors | Chung-Shiuan Hung, Ming-Shean Chou, Chung-Shin Yuan, Cheng-Di Dong |
| Publisher | NSYSU |
| Source Sets | NSYSU Electronic Thesis and Dissertation Archive |
| Language | Cholon |
| Detected Language | English |
| Type | text |
| Format | application/pdf |
| Source | http://etd.lib.nsysu.edu.tw/ETD-db/ETD-search/view_etd?URN=etd-0906105-173043 |
| Rights | unrestricted, Copyright information available at source archive |
Page generated in 0.0021 seconds