Return to search

Fluid Extraction of Metals from Coal Fly Ash: Geochemical Simulation of Natural leaching

The objective of this study was to develop data that are broadly applicable to the release of trace metals from fly ash, and to quantify the rate of release as a function of the composition of the ash. Thirty-two samples of Class F fly ash from pulverized coal combustion boilers were leached with seven leaching solutions simulating natural fluids. The leachate was analyzed for 21 cations that were major, minor, or trace constituents of the ash. The rate at which metal ions are released from fly ash is a complex function of the alkalinity of the ash, the distribution of elements in various chemical compounds or minerals, and characteristics of the leachant solution, particularly its pH. In this experiment, the release of cations is defined as a solubility function with respect to the volume of leachant solution. During the first leaching interval, the ashes alkalinity is neutralized, and the release of metal ions, except for Ca, is relatively low. At some point, the release of metal ions increases by one or more orders of magnitude, and remains at that level, until the readily soluble ions are released. Then the elemental release decreases, again by one or more orders of magnitude.
The solubility of an element is defined by the three volumetric functions and the median volumes for those functions. The N LF (neutralization leaching function) is describes the release of cations until the sample is neutralized (dMN/dVN, meq/L). The RLF (rapid leaching function) rate is the average slope of cumulative curve between inflection points (dML/dVL, meq/L). The TLF (terminal leaching function) is the average slope of cumulative curve after 2nd inflection point (dMT/dVT, meq/L). In a natural setting, if the infiltration rate is known (L/d), the time dependent release of the elements can be estimated. The results of this study show that most cations in fly ash are only slightly soluble, that elements, other than arsenic, tend to be most soluble in acid solutions, and that non-silicates tend to be more soluble than silicates.

Identiferoai:union.ndltd.org:PITT/oai:PITTETD:etd-05082002-093040
Date06 August 2002
CreatorsKim, Ann Gallagher
ContributorsHarold Rollins, Ronald neufeld, Brian Stewart, Rosemary Capo, Michael Bikerman
PublisherUniversity of Pittsburgh
Source SetsUniversity of Pittsburgh
LanguageEnglish
Detected LanguageEnglish
Typetext
Formatapplication/pdf
Sourcehttp://etd.library.pitt.edu:80/ETD/available/etd-05082002-093040/
Rightsunrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to University of Pittsburgh or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report.

Page generated in 0.0021 seconds