Return to search

Influence of median grain size ratio on the strength and liquefaction potential of loose granular fills

<p> The characterization of silty soils is usually designated by the percentage of silt contained within the soil matrix, along with the soil&rsquo;s void ratio, which is used to describe the soil&rsquo;s current state. The use of these parameters to assess a soil&rsquo;s strength and undrained behavior is limited when finer material is contained within the soil. Therefore, additional parameters must be considered in order to correctly assess the strength and liquefaction potential of silty soils. These additional parameters include the skeleton void ratio, equivalent void ratio and granulometric factors. The current research investigates the influence of granulometric parameters, specifically the Median Grain Size Ratio (<i>D</i><sub>50</sub>/<i> d</i><sub>50</sub>), denoted as &mu;<sub>DR</sub> (or MDR within graphs and charts), on the strength and liquefaction potential of loose silty sands. A series of undrained monotonic triaxial compression tests (&sigma;3&rsquo;= 69, 83, and 103 kPa) are performed on reconstituted soil samples, using three different base sand samples and a constant silt material. As a result, three distinct median grain size ratios (&mu;<sub>DR</sub> = 4.2, 6.75, and 9) were tested with fines content ranging from 0-30% for each &mu;<sub>DR</sub>. The undrained shear strength at all confining pressures tends to increase with in &mu;<sub>DR</sub>; beyond 10% fines content there was no noticeable influence of &mu;<sub>DR</sub>. At any &mu;<sub>DR</sub> the excess PWP is higher than that of clean sand, when fines content is larger than 5% fines content. The slope of the instability line and phase transformation line are directly affected by the &mu;<sub>DR</sub> and fines content, with an increase in the instability line and decrease in the phase transformation line with a growing &mu;<sub> DR</sub>. The results indicate loose granular fills can be designed to be stronger and more resilient under extreme conditions by careful choice of materials in which the &mu;<sub>DR</sub>>6.75 and the fines content does not exceed 10%.</p>

Identiferoai:union.ndltd.org:PROQUEST/oai:pqdtoai.proquest.com:10172612
Date13 October 2016
CreatorsWaganaar, Spencer
PublisherFlorida Atlantic University
Source SetsProQuest.com
LanguageEnglish
Detected LanguageEnglish
Typethesis

Page generated in 0.1704 seconds