Return to search

Impact resistance of concrete

During its service life, a structure may be subjected to various environmental and loading conditions. However, in general, the properties determined under one set of conditions may not be used to determine the behaviour of the material under a different set of conditions. For example, it is well known that concrete is a strain rate sensitive material; therefore, its properties determined under conventional static loading cannot be used to predict the performance of concrete subjected to high strain rates. The problem is serious because these high strain rate loadings are associated with large amounts of energy imparted to the structure in a very short period of time, and concrete is a brittle material. Since the strain rate sensitivity of concrete prohibits the use of its statically determined properties in assessing its behaviour under dynamic conditions, high strain rate tests are required.
Impact tests were carried out on about 500 concrete beams. An instrumented drop weight impact machine was used. The instrumentation included strain gauges mounted in the striking end of the hammer (called 'the tup'), and also in one of the support anvils. In addition, three accelerometers were mounted along the length of the beam in order to obtain the beam response, and also to enable the inertial correction to the observed tup load to be made. Two different concrete mixes, normal strength with a compressive strength of 42 MPa, and high strength with a compressive strength of 82 MPa, were tested. The effect of two types of fibres, high modulus steel, and low modulus fibrillated polypropylene, in enhancing concrete properties was investigated. In addition, tests were also conducted on beams with conventional reinforcement. Hammer drop heights ranging from 0.15m to 2.30m were used. Static tests were conducted on companion specimens for a direct comparison with the dynamic results.
In general, it was found that concrete is a very stain rate sensitive material. Both the peak bending loads and the fracture energies were higher under dynamic conditions than under static conditions. Fibres, particularly the steel fibres, were found to significantly increase the ductility and the impact resistance of the composite. High strength concrete made with microsilica, in certain circumstances, was found to behave in a far more brittle manner than normal strength concrete.
High speed photography (at 10,000 frames per second) was used to study the propagation of cracks under impact loading. In general, the crack velocities were found to be far lower than the theoretical crack velocities. The presence of reinforcement, either in the form of fibres, or of continuous bars was found to reduce the crack velocity. A model was proposed based on a time step integration technique to evaluate the response of a beam subjected to an external impact pulse. The model was capable of predicting not only the experimentally observed non-linear behaviour of concrete under impact loading, but also the more pronounced brittle behaviour of high strength concrete. / Applied Science, Faculty of / Civil Engineering, Department of / Graduate

Identiferoai:union.ndltd.org:UBC/oai:circle.library.ubc.ca:2429/26956
Date January 1987
CreatorsBanthia, Nemkumar P.
PublisherUniversity of British Columbia
Source SetsUniversity of British Columbia
LanguageEnglish
Detected LanguageEnglish
TypeText, Thesis/Dissertation
RightsFor non-commercial purposes only, such as research, private study and education. Additional conditions apply, see Terms of Use https://open.library.ubc.ca/terms_of_use.

Page generated in 0.0019 seconds