A study of the squish-jet design concept in spark ignition engines, with central ignition, was conducted in a constant volume chamber. The effects of jet size, jet number and jet orientation in generating turbulence and jet enhanced turbulent combustion were investigated. Three sets of configurations with three port sizes were used in this study. The research was carried out in three stages:
1.Qualitative information was obtained from flow visualization experiments via schlieren photography at 1000 frames per second. The flow medium was air. A sequence of frames at specific time intervals were selected to study the results from the respective configurations
and jet sizes. The swirling nature of the flow is vivid in the offset arrangement.
2.Pre-ignition pressure and combustion pressure traces were measured with a piezoelectric
pressure transducer from which characterising parameters such as maximum pressure,
ignition advance and mass burn rate were analysed. Mass fraction curves were calculated
using the simple model of fractional pressure rise. A maximum pressure increase of 66% over the reference quiescent combustion case, and combustion duration reduction of 77% were obtained for the offset arrangement with 2 mm diameter port. Comparisons of the times required for 10%, 50% and 90% mass burned are identified and confirmed that it took the 2 mm jet the shortest time to burn 90% of the mixture in the chamber.
3.Two-component velocity measurements were made using an LDV system. Measurements
were taken in the central vertical plane of the chamber at specified locations. The data collected were window ensemble- averaged for the mean and fluctuating velocities over a number of cycles. Data intermittency and low data rate precluded, however, cycle-by-cycle analysis. Mean tangential velocities were calculated for each case and the data
were used to construct a movie of the tangential velocity as a function of time, suitable for quantitative flow visualization. The vortical nature of the flow was recorded, the distribution being neither solid body rotation nor free vortex, but some complex fluid motion.
The jet scale and orientation influence the in generation of turbulence flow field in the chamber, affecting the rate of combustion and the ensuing maximum pressure rise. The offset jet arrangement gives the best results, whereas radially opposed jets have a reduced effect. Increasing the number of jets in opposed arrangement does not enhance turbulent flow. Turbulent flow in the spark region during the onset of ignition was found to be important. / Applied Science, Faculty of / Mechanical Engineering, Department of / Graduate
| Identifer | oai:union.ndltd.org:UBC/oai:circle.library.ubc.ca:2429/29969 |
| Date | January 1991 |
| Creators | Gete, Zenebe |
| Publisher | University of British Columbia |
| Source Sets | University of British Columbia |
| Language | English |
| Detected Language | English |
| Type | Text, Thesis/Dissertation |
| Rights | For non-commercial purposes only, such as research, private study and education. Additional conditions apply, see Terms of Use https://open.library.ubc.ca/terms_of_use. |
Page generated in 0.0147 seconds