Return to search

Evaluation of Automated Test Generation for Simulink : A Case Study in the Context of Propulsion Control Software

Automated Test Generation (ATG) has been successfully applied in many domains. For the modeling and simulation language Simulink, there has been research on developing tools for ATG with promising results. However, most tools developed as part of academic research and are not publicly available, or severely limited in their ability to be integrated into an industrial workflow. There are commercial ATG tools for Simulink, with Simulink Design Verifier (SLDV) as the de-facto standard tool. For this thesis, we perform an empirical comparison of manual tests to those generated by SLDV. For the comparison, we used 180 components from the propulsion control software developed by our industry partner. All except two components are compatible for test generation to some extent. The majority of components are partially compatible, requiring block replacement or stubbing. Approximation of floating-point numbers is the primary reason for block replacement, which can be performed automatically by SLDV. Two components were incompatible, and 14 required full stubbing of blocks. Using a pre-processing step, the generated tests achieve similar coverage as the manual tests. We performed a Mann–Whitney U test with the hypothesis that the generated tests achieve higher coverage than the manual tests. There are no statistically significant differences for either decision coverage (0.0719), or condition coverage (0.8357). However, for Modified Condition/Decision Coverage, the generated tests achieve higher coverage, and the difference is significant (0.0027). The limitations of ATG were explored by looking at the cases where the generated tests achieved lower coverage than the manual test. We found that the use of floating-point arithmetic and temporal logic increases the time required for test generation, and causes the analysis to hit the time limit. The test generation does not support all custom S-functions and perform stubbing of these blocks. This made the tool unable to reason about persistent storage. Configuration constants have limited support, which was the reason for the coverage difference in three cases. We have concluded that while much effort is required for custom tooling and initial setup, ATG can prove useful for early fault detection in an industrial workflow. ATG would prove especially useful in an automated continuous integration workflow for integration-level conformance testing.

Identiferoai:union.ndltd.org:UPSALLA1/oai:DiVA.org:mdh-48426
Date January 2020
CreatorsRoslund, Anton
PublisherMälardalens högskola, Akademin för innovation, design och teknik
Source SetsDiVA Archive at Upsalla University
LanguageEnglish
Detected LanguageEnglish
TypeStudent thesis, info:eu-repo/semantics/bachelorThesis, text
Formatapplication/pdf
Rightsinfo:eu-repo/semantics/openAccess

Page generated in 0.0027 seconds