Heat pipes are passive heat transfer devices in which a working fluid is sealed inside a metal enclosure. Properly designed wick structures on the inner surface of the heat pipe are critical as the wick aids in the return of the condensed liquid from the cold end back to the hot end where the vaporization-condensation cycle begins again. Additive manufacturing techniques allow for manufacturing complex parts that are typically not feasible with conventional manufacturing methods. Thus, additive manufacturing opens the possibility to develop high performance heat pipes with complex shapes. In this study, an additive manufacturing technique called Binder Jetting is used to fabricate a fully operational compact (78 mm x 48 mm x 8 mm) flat plate heat pipe. Rectangular grooves with converging cross section along the length act as the wicking structure. A converging cross section was designed to enhance the capillary force and to demonstrate the capability of additive manufacturing to manufacture complex shapes. This work describes the challenges associated with the development of heat pipes using additive manufacturing such as de-powdering and sintering. Multiple de-powdering holes and internal support pillars to improve the structural strength of the heat pipe were provided in order to overcome the manufacturing constraints. The heat pipe was experimentally characterized for thermal performance with acetone as the working fluid for two different power inputs. The heat pipe operated successfully with a 25% increase in effective thermal conductivity when compared to solid copper. / Master of Science / The number of transistors in electronic packages has been on an increasing trend in recent decades. Simultaneously there has been a push to package electronics into smaller regions. This increase in transistor density has resulted in thermal management changes of increased heat flux and localization of hotspots. Heat pipes are being used to overcome these challenges. Heat pipes are passive heat transfer devices in which a working fluid is sealed inside a metal enclosure. The fluid is vaporized at one end and condensed at the other end in order to efficiently move heat through the pipe by taking advantage of the latent heats of vaporization and condensation of the fluid. Properly designed wick structures on the inner surface of the heat pipe are used to move the condensed fluid from the cold end back to the hot end, and the wick is a critical component in a heat pipe. Additive manufacturing techniques offer the opportunity to manufacture complex parts that are typically not feasible with conventional manufacturing methods. Thus, additive manufacturing opens the possibility to develop high performance heat pipes with complex shapes as well as the ability to integrate heat exchangers with the heat source. In this study, an additive manufacturing technique called Binder Jetting is used to fabricate a fully operational compact (78 mm x 48 mm x 8 mm) flat plate heat pipe. Rectangular grooves with converging cross section along the length act as the wicking structure. This work describes the challenges associated with the development of heat pipes using additive manufacturing such as depowdering and sintering. The heat pipe was experimentally characterized for thermal performance with acetone as the working fluid for two different power inputs. The heat pipe was found to operate successfully with a 25% increase in effective thermal conductivity when compared with solid copper.
| Identifer | oai:union.ndltd.org:VTETD/oai:vtechworks.lib.vt.edu:10919/99051 |
| Date | 18 June 2020 |
| Creators | Ravi, Bharath Ram |
| Contributors | Mechanical Engineering, Huxtable, Scott T., Diller, Thomas E., Paul, Mark R. |
| Publisher | Virginia Tech |
| Source Sets | Virginia Tech Theses and Dissertation |
| Detected Language | English |
| Type | Thesis |
| Format | ETD, application/pdf |
| Rights | In Copyright, http://rightsstatements.org/vocab/InC/1.0/ |
Page generated in 0.0029 seconds