Dynamic properties of soils (shear stiffness and damping ratio) are critical for the design of structures subjected to vibrations. The dynamic properties of a benchmark standardized laboratory sand (Ottawa silica sand) were evaluated with two different resonant column devices, utilising software with different analytical approaches for the evaluation of soil properties. The dynamic properties (shear modulus and damping ratio) are evaluated as a function of the shear strain level. The results are compared to evaluate the effect of the type of equipment and the form of the data analysis on the measured dynamic properties of the samples. The results are discussed in light of the applicability of the procedures in practice, the ease of the testing methods, and the errors they introduced into analysis and design. In general, the shear wave velocities obtained from the two different devices are in good agreement. However, the damping ratios they give show considerable differences as strains increase.
Dynamic properties are typically measured by curve fitting of the transfer function between the excitation and the response using the resonant column device. However, the force function generated by sinusoidal sweep or random noise excitations induce different shear strain levels at different frequencies. Consequently, the shape of the measured transfer function is distorted and differs from the theoretical transfer function for an equivalent single-degree-of-freedom system. The difference between the measured and theoretical transfer functions as well as the bias in the computed dynamic properties becomes more pronounced with the increase in shear strain. This study presents a new methodology for the evaluation of dynamic properties from an equivalent constant-strain transfer function. The soil specimen is excited simultaneously using a sinusoidal excitation (carrier signal) at the required strain level and a small amplitude, narrow band random noise. The strain level induced by the fixed sine is shown to control the resonant frequency of the specimen; whereas the random noise introduces the required frequency bandwidth to determine the transfer function and hence the dynamic properties at a constant strain level. The new methodology also shows a good potential for the evaluation of frequency effects on the dynamic properties of soils in resonant column testing.
| Identifer | oai:union.ndltd.org:WATERLOO/oai:uwspace.uwaterloo.ca:10012/6563 |
| Date | 17 February 2012 |
| Creators | Moayerian, Soheil |
| Source Sets | University of Waterloo Electronic Theses Repository |
| Language | English |
| Detected Language | English |
| Type | Thesis or Dissertation |
Page generated in 0.0015 seconds