The influence on the as-cast grain size of a range of alloying additions to some TiAI-based alloys has been assessed using optical microscopy, analytical scanning and analytical transmission electron microscopy. It has been found that additions of boron, either as TiB2 or AlB 12,resulted in significant grain refinement, but of the other additives (yttrium, yttria, silicon and sulphur) only sulphur had any significant effect. Measurements of tensile properties of the grain refined alloys showed a significant improvement, and creep rates were not degraded. Failure of the fully lamellar structure during tests was found to occur by the splitting of grains, in the hard orientation, parallel to the lamellae. Determination of the nature of B-containing precipitates in the alloys, formed at high cooling rates, showed that they were a eutectic structure of either TiB and B2 or TiB2 and B2 depending upon alloy composition. At lower cooling rates TiB2 usually formed, unless Ta was present in the alloy in which case a complex structure of TiB and TaB formed. In all cases, irrespective of the alloy or boron addition method, a minimum concentration of about 0.6 at.% B was required to achieve an equiaxed grain structure in plasma-melted ingots. At lower concentrations the dendrite arm spacing and columnar grain width are reduced. In Ta and W-containing alloys there is a marked tendency for the borides to form large (400J.1m) clusters. The size and frequency of these clusters can be influenced by the sequence and the form in which the various alloying additions are made. The mechanism by which grain refinement occurs is the rejection of boron from the liquid during solidification, leading to local high concentrations of boron at the roots of the secondary dendrite arms, which under normal casting conditions then break off and act as nuclei for equiaxed grains. The boron is then precipitated, as eutectic phase, in the interdendritic regions. Under quiescent casting conditions grain refinement does not occur with concentrations of boron sufficient to refine plasma-melted material, although again the boron precipitates interdendritically. Grain refined samples forge with very little cracking under conditions which result in extensive cracking in non grain refined samples. Zener pinning of the grains by the borides ensures that grain growth in the forged and forged plus heat treated material is very slow. These results are discussed in terms of the importance of grain refinement in TiAI-based alloys.
| Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:251179 |
| Date | January 1996 |
| Creators | Godfrey, Alastair Bryan |
| Publisher | University of Birmingham |
| Source Sets | Ethos UK |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
Page generated in 0.002 seconds