Flow accelerated corrosion is a piping degradation mechanism that results in pipe wall thinning due to the dissolution of the magnetite oxide layer on carbon steel surfaces to the bulk flow. The rate limiting process of flow accelerated corrosion in piping system is the diffusion-controlled mass transfer. The surface roughness develops due to the mass transfer and can subsequently have a significant effect on the mass transfer. The naturally developing surface roughness in many dissolving surfaces, including carbon steel pipes, is a densely packed array of saucer shaped depression called scallops, which can have several length scales. Heretofore, the developing roughness on soluble walls has not been quantified, mainly due to the lack of a reliable measurement methodology.
The overall objective of this research is to investigate the developing roughness and the corresponding mass transfer on soluble walls in different piping geometries. A wall dissolving method using gypsum test sections dissolving to water in a closed flow loop was used to mimic the mass transfer in carbon steel pipes due to a similar Schmidt number of 1200. A novel non-destructive measurement technique using X-ray CT scans was developed to measure the development of surface roughness and the corresponding mass transfer. The method was validated by performing experiments using straight pipe test sections and comparing against traditional measurements method using ultrasonic sensors, coordinate measurement machine and laser scans.
The time evolution of surface roughness and the corresponding mass transfer were measured in pipe test sections at Reynolds number of 50,000, 100,000 and 200,000. The roughness scallops were observed to initiate locally and then develop until the surface is spatially saturated. The surface roughness was characterized by the RMS height, peak-to-valley height, integral length scale, density and spacing of the scallops. Two time periods of roughness development were identified: an initial period of slower growth in the roughness height followed by a relatively higher growth rate that corresponded to the period before and after the surface saturates with the scallops. The mass transfer enhancement due to the roughness in each of these time periods was also found to be different, with a higher increase in the first period followed by a slower increase once the streamwise spacing was approximately constant. Both the height and spacing of the roughness elements was found to affect the mass transfer enhancement. A new correlation is proposed for the mass transfer enhancement as a function of the height-to-spacing ratio of roughness, with a weak dependence on Reynolds number.
The measurement methodology was extended to study the mass transfer and developing roughness in a complex S-shaped back to back bend at Reynolds number of 200,000. The mass transfer in bend geometry can be enhanced by both the local flow due to the geometry effect and the developing roughness. Two high mass transfer regions were identified: at the intrados of the first and second bends. The height-to-spacing ratio of the roughness was found to increase more rapidly in these high mass transfer regions. An additional one-time experiment was performed at a Reynolds number of 300,000. A higher surface roughness with smaller values of spacing-to-height ratio was found in the regions with high mass transfer. / Thesis / Doctor of Philosophy (PhD)
| Identifer | oai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/20508 |
| Date | January 2016 |
| Creators | Wang, Dong |
| Contributors | Ching, Chan, Mechanical Engineering |
| Source Sets | McMaster University |
| Language | en_US |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0019 seconds